Recent content by Drooque

Update: Worked great, huge improvement over old Nakamichi sub.

My gut feeling has always been .9 would be good. I came here looking for confirmation, which I have received. I used to make a living installing systems and building custom enclosures. Had customers that had a great deal of success in both spl and sq competitions. I had fancy software on my...

Their website says 0.5.

I did order the DS18 SLC10S, and it should be delivered today. I started planning on shrinking the box from .9 to .5 cubic feet, and realized it won't be simple. Putting that much 2x4s and 2x6 in through the 10 inch hole is going to be difficult. Any suggestions?

What about .9 sealed? Shirk?

Hello, I am replacing a sub in a 0.9 cubic foot enclosure with 5.5" mounting depth (wedge behind the seat). I am looking at the DS18 SLC10S sub, but am worried the volume is too large. I could also possibly put a port in the enclosure, but I wouldn't know what size to make it. Any...

Thank you everyone. I ordered the JBL Club A600. Felt like I couldn't pass it up at $150 shipped. I'll keep an eye out for a good deal on a matching 4 channel down the road, as I can get by running off the head unit for now. I did take a serious look at the Sundown amps, but felt they were a bit...

How about a CT Sounds CT-1000.1D? I know their have been reports of fire, but I wonder if that would be a non issue going into 4 ohms. Also, I wonder if that is only in certain other models. The struggle I am having is that I also want a 4 channel amp, and I would like them to match. I like the...

I really appreciate the feedback. Zaramps makes the MD 250.1 in a 2 or 4 ohm version. It puts out a bit more power than the Bass 400, but it's designed more for full range. Perhaps it would be a better choice for the 4ohm sub? The Infinity Sub is actually the 1270B that comes preloaded in a...

Thank you for your response. How do you know what the Infinity will do? I couldn't find any 4 ohm information for it. If neither of these, what is the least expensive amp you would recommend?

Please help me decide between those two Amps to power Infinity Primus 1270 12" Subwoofer (already own) at 4 Ohms? Thank You

You would think it wouldn't be too hard to figure out if you can run a 3 way active front stage off my head unit, but it was a pain, with all the firmware upgrades, convoluted settings, etc. But alas, I cannot. So: 1. How terrible would it sound to run two sets of component 6.5" (front and rear)...

Thank You hispls!

Hello Everyone, I asked a question under the speaker section about the components for this system, but didn't get any answer. Since then, I have looked into a bunch more. Currently, I have the following in a cart, ready to purchase: Blaupunkt AMP1604 Blaupunkt AMP3000D 2 x MTX Terminator6S I...

I guess my post was to vague, lol, I really thought I would have gotten some feedback by now. Anyway, If I could make an active front, would MTX Terminator6S be any good. www.amazon.com/MTX-Terminator-Woofer-Component-Speaker/dp/B07NP33DR1 The $50 price is quite appealing.