Recent content by Dmascarel

hmm, any ideas what I could wire it to, not sure what would be a 12v power source

Also If in fact the Red adapter is supposed to be the power source for 12v, what is the "Yellow - 12v Constant" for?

Ok I have a question about a wiring harness I ordered from Ebay Yellow – 12V Constant Red – 12V Accessory Black - Ground Orange – Dash Light Dimmer Green – Left Rear Speaker (+) Green with Black Stripe Left Rear Speaker (-) White – Left Front Speaker (+) White with Black Stripe – Left...

Bump. Nobody has any idea if this is good or bad?

I have an old Zapco reference 150 watt 2 channel amp, I am wanting to wire 4 6x9s to it but Im thinking it wont be near enough power wise to run the 6x9s, I got 4 kicker 6x9 ds series which are about 70 watts rms, I know the zapco amp is underrated a bit, when i bought it the actual power output...

Ok then this leads to my next question, What are some good 6x9s for about $100 bucks a pair ($200 for all 4) that would be good with an old zapco reference 150 watt amp.

I was thinking 6x9s just because its easier, and I figured 6x9s would be sufficient for me, im just not sure the qualiy of vocals would be enough to match the b*** from the subs, not alot of experience with 6x9s

I have a dodge charger which is 6x9s in the front doors and 6x9s in the rear deck, should I change my front door speakers to components or should I just get 6x9s all the way around, im wanting to change out all the factory equipment, but not sure if I should have 4 6x9s or do 6x9s in the rear...

Ok ill see if I can find it somewhere.

Ok so i get the concept that my subs are 4 ohm so I cant wire them at 2 ohms I have to wire them down to 1ohm, but how do I adjust the gain accordingly, the amp does not have an actual "gain" it has a Bass boost control, sub sonic control, low pass control, and a level control. so how would I...

Thanks for the advice but that doesnt really help my question...

Wouldnt 1 Ohm be to many watts?

..

Ok I am running a Crunch 2000.1 Amplifier on 2 kicker comp Vr subs. The Crunch GPV 2000.1 amp is 250 watts rms @ 4 ohms, 500 watts max @ 4ohms 500 watts RMS @ 2 ohms, 1000 watts max @ 2ohms 1000 watts @ 1ohm, 2000 watts max @ 1ohm My kickers are 400 watts RMS, 800 watts max Am I better off...

Ok I am running a Crunch 2000.1 Amplifier on 2 kicker comp Vr subs. The Crunch GPV 2000.1 amp is 250 watts rms @ 4 ohms, 500 watts max @ 4ohms 500 watts RMS @ 2 ohms, 1000 watts max @ 2ohms 1000 watts @ 1ohm, 2000 watts max @ 1ohm My kickers are 400 watts RMS, 800 watts max Am I better off...