Recent content by Dirtym

Another question I had was when the volume is turned all the way off I can here a slight constant hum coming out of the speakers. Almost like there is some sort of interference. Anyone know why it's doing that?

well the LOC was set up for the most sound, there was a small setting on the amp that allowed more sound to come out. It's just a weak set up but with the base turned up It should be okay. THanks for the help.

There are two different dials on the loc should I turn them both the same I assume?

I just installed a 2 channel 4 ohm amp with 2 10 inch 4 ohm subs. I am using my factory head unit and tied in a LOC. The LOC RCA's were not red/white they were labeled L and R so I just matched them up on the amp. I believe the white was L. I switched the LPF to on. When I turned on the stereo...

1000W max power - 165W x 2, 20Hz - 20kHz, @ 0.04% THD + N, at 4 Ohms - 200W x 2, 20 - 20kHz, @ 0.15% THD + N, at 2 Ohms - 400W x 1, 20Hz - 20kHz, @ 0.1% THD + N, at 4 Ohms - OTL (Output Transformerless) circuit - Pulse power supply - Line & High Level Inputs - .3-6V Level Adjustment...

Okay, thanks for the advice. so I guess it would bee pointless to run the subs in parallel then? I guess if I were to bridge it I would only be turning the ampm into 2 ohm and the speakers the same, not really sure what hte point in that would be or if I am even understanding it correctly. I...

That is if I don't bridge it. I don't know what it will put out once bridged. I don't know if the amp is stable at 2ohm or if the speakers are stable at 2 ohm. I know I could simply hook it up normally 1 channel per speaker but, if there is a better option; I'm open to suggestions.

Thanks for the link. My question following is, is this an actual option for me? Hoping maybe someone that is familiar with this amp can tell me if its safe and or what the best option is to get optimal power. I don't want to over work the speakers and/or amp. granted I hardly have any money in...

Sup guys I'll cut to the chase, It's probably a stupid question but I don't know a ton about audio stuff so I apoligize in advance. I have a sony 1000w 4 ohm 2 channel amp. I have 2 Infiniti reference 10'' 4 ohm subs. I am wondering the best way to hook this up. I know that some people bridge...