Recent content by dirk41*

So this is a very basic setup: 1 mono amp for two ten inch subs 1 4 channel amp for front and back speakers kenwood headunit So I have had zero problems with this setup up for about a year now, and nothing has changed. I got into my car today turned it on and a very high pitched squeal is...

That is a great deal Av however I couldn't run it at 2ohm. I can only wire my subs to 1 or 4 ohm on a mono amp... Plus i am picking up the MTX amp for 40 bucks through a friend.

I have two JBL GT5-10D - they are 4ohm DVC subs The amp I currently have is a Kenwood KAC-7203

Ok, so as of right now I am running 2 10" JBL subwoofers off of a (two channel) kenwood amp. Each speaker is receiving 250watts RMS at 2ohms. It sounds great but the amp gets super hot. So I am looking at purchasing an MTX monoblock class D amp that can put out 500watts RMS at 4ohms. So I would...

av83 so basically there is no way to wire this speaker up at all unless I used an amp, or if the speaker was a 4ohm svc?

Thanks for the suggestions, but I'm just really wondering if this can be done.

Ok so this is my setup right now. 4 channel kenwood amp wired up to my front door speakers and the speakers in the rear deck. 2 channel kenwood amp wired to my two DVC 10" subs in the trunk Head unit is completely unused as far as being wired to speakers. However, my car has a 6.5 sub in the...