Recent content by Deamonicus3

It's a power acoustik 4 ch ps4-600. The specs say it produces 70X4 @4 ohms. If I bridge 2 ch I get 170 wrms @ 4 ohms. I can't do 2 ohm.

Whoops that's 4 ohms.

http://www.installdr.com/ Dude that FVCKEN link sucks. I keep giving me errors. I had to go to taskman to shut it down!!!!

I've got an amp that will put out 170 wrms and I have a 1.0 cu ft box that can be ported or not. I need help finding a 10" sub for this set up. I'm cheap so lets try and keep it under $100. I'm more interested in sq than noise but I still want it loud.

OK I put the sub in the car with the port tube in it. I didn't cut it yet. I just wanted to see if there was any difference in sound. Well even with it not being "tuned" correctly, it sounds alot better. The port is on top of the box and I have about 5 inches of clearance. Well I basically did...

I don't think I can change the diameter of the port. It is a premade Q-Logic box. It came with a port plug in it. I can use it sealed or ported. I took the port plug out and and put in the tube and it almost hits the bottom of the sub. It's only about a 1/2" off the bottom so I think I have to...

3 1/4"

I've got a Q-Logic 1.0 cu ft sub enclosure. It can be used sealed or ported. Well I've had it sealed for a while and I'd like to see the difference porting makes. It has a precut hole that has a plug in it. It also came with a 12" tube to be used for porting. I just can't figure out how long the...

I regrounded the amp at the seatbelt anchor. I tried adjusting the gain but I even hear the whine with the gain turned down to half and then I have no volume. I may try to ground the radio with the amp and see what that does. Thanks for the help guys.

The gains were set at about 3/4. I may turn them down a bit. Yeah both ground connections were sanded. If I change the amp ground where is the best place to put it?

I've got a very faint high pitch whining coming from the speakers. I hear on start up before the amp powers up and sometimes when the music dips low enough. I used a scorche loc and gounded it behind the dash in the radio cut out. The radio is also grounded here. It looked like a decent ground...

What's the best set of components I can get for under $100. I've only seen some pioneer's and some infinity's on there in that price range. Is that it?

Thanks guys. I had to adjust the low and high pass filters. The fronts were getting a low bass frequency that was causing them to distort. It sounds alot better now but I'll still be looking for components up front.

I'm still a newbie but have asked questions like this in the past. The response I usually get is to amp up the front speakers, run the back speakers off the head unit and then add a small sub for the rear. You should be able to bridge 2 channels off your amp to power the sub. I forgot to ask...

I thought kicker was a pretty good name in car audio. On the advice of a car audio dealer I bought some kicker 6.5 for my doors. They were either dx 65 or 69. Something like that. Anyway they sounded ok hook up to a 65 wrms 2 ch amp. But if the bass was set too high they popped. Well the amp was...