Recent content by d-aguil9

Thanks for all the help guys, I tapped into the door speakers at the amp and all is well. Owner of vehicle is still going to upgrade loc to the audio control unit to restore bass at higher volume.

Thanks for the reply, and in order to use a signal after the amp I would have to upgrade the loc to a higher rated unit? Is this correct, I tried tapping in after the amp and it resulted in no signal.

Update I tapped into the wires before the amp and now I do have an audio signal but when stereo is muted sub woofer continues playing and volume only controls car speakers sub never changes. What could be going on,

Thanks I'll make sure and wire the sub to 4 ohms

Thanks for the link the first one looks like it will plug right in, and yes I bridged the two channels for the sub

Amp is a older model kicker zx200.2

For the remote circuit I picked up a add a circuit fuse holder and installed it in the power point fuse slot, and yes the amp dies have a high level input. It looks like it takes a connector in order to plug into the high level input, connector is no where to be found any idea where I could...

Thanks for the reply I'll give it a shot and update with results.

Recently installed an amplifier in a 06 lexus is250 wired in a dirt cheap scosche loc-80, for the input wires i used the factory subwoofer wires coming out of the factory amp. Upon testing I found no sound from sub, all powers and ground ok, my question is do i need to tap into a set of wires...