Recent content by cversion7

  1. cversion7

    just ordered my 12 inch sx....

    psst... *links to private messages don't work*
  2. cversion7

    cversion7 Feedback thread

    duece212 - purchased a wcc5000 from him. It arrived very quickly and with excellent communication the whole time. Thanks!
  3. cversion7

    Noob ?....Model #?

    http://www.pioneerelectronics.com You can view the screensavers for each head unit there.
  4. cversion7

    my girlfriend

  5. cversion7

    Orion 2500D no louder than JL 500/1

    There are a lot more wires involved in the big three and without upgrading them all, you're still going to be limiting available power to the smallest one. My alternator to battery wire (stock) was like 12 gauge. I added 4 ga to that, added a 4ga battery neg to chassis ground and one from...
  6. cversion7

    1800w RMS Mono D

    Orion 2500d would work well. I don't know if it has a bass knob though.
  7. cversion7

    Alpine 1242D Type-R

    http://forums.caraudio.com/vb/showthread.php?t=45618
  8. cversion7

    November raffle!

    5 tickets bought *fingers crossed*
  9. cversion7

    Help with camry- please

    BIG 3 BIG 3 BIG 3 Enough said.
  10. cversion7

    Profile Amp question....

    I think you meant to ask, "What is SSF?" SubSonic Filter - It's used to keep your speakers from getting frequencies that are too low for them. It's a crossover setting usually geared for subs so you don't bottom them out by playing notes well below the tuning frequency of your box.
  11. cversion7

    My first glassing worklog. Sub enclosure

    Second picture, see if you can smooth out that big wrinkle before putting resin down. I'm sure it's easier said than done, of course, but should help out with strength of the enclosure and you won't have to fill it later. Great work, though!
  12. cversion7

    2 bridge channels in stereo??

    As long as your amp is bridgeable, then you should be able to bridge the left channels (front/rear) and right channels (front/rear) in order to get bridged stereo output. It worked on my Orion 4004.
  13. cversion7

    I need assistance!

    Okay, I just called Orion(Directed) and asked them. They said that in bridged mode (@ 4 ohms) it would mono the two channels I'm bridging but I would still get a dedicated left and right channel out of it. I guess I'll just have to wait until I can test it out to be sure, but I was curious if...
  14. cversion7

    I need assistance!

    I just got an Orion 4004 amp. I got it to run my PG Elite Ti 5 set for my front speakers. They are 300WRMS and this amp will do 200x2 @ 4ohms so I thought it would be a good match. However, now looking at the instructions and not having seen this anywhere before, it looks like if I bridge the...
Top