Recent content by cuddy8888

Thank you. Appreciate the help.

goal is to run components as BI AMP up front rear fill. I am also using. Rockford DSR1, but assumed that would come out of the equation since I’m putting in an aftermarket radio? Could I leave the DSR1 in, use that 8th channel on it, and still use the aftermarket radio with no issue...

I have two amplifiers: Rockford Fosgate: T1000X5AD Rockford Fosgate: T400X2AD Kenwood Excelon Reference Components Up front Hertz coaxials in the rear Rockford 10 in sub My radio, Kenwood DMX1057XR only has 6 pre-amp outputs. How do I solve the problem of using all six pre-amp outputs on...

Basing it off the clipping indicator on the amp playing a 1Khz at 0DB test tone. Speakers are loud for sure but sound nothing like I have heard them before. Beginning to think Kenwoods weren’t the right speaker to go with this amp. May look into switching them for some Rockford’s

Measured in at 18.3 volts per channel so it’s definitely getting the wattage as advertised by the amp per channel. Would bridging the 4 Channel to 2 Channel help any just on the front stage? Those speakers can definitely handle 200 watts.

Just finished installing a full system in my 2017 F150 (had the factory Sony package). Stock factory 8 inch radio Rockford Fosgate DSR1 to by pass factory amp (4 gauge power wire and ground wire direct from the battery) Rockford Fosgate T1000X5ad amp Kenwood Excelon XR-1801P 7" Component...