Recent content by cpcg32

I was wonering if there are any better comps than the eDi 6000s that cost less than $140? That is the most I am willing to spend, I know they may not be as some rainbows and whatever but I am not trying to create the worlds best system. I just want something that sounds good. I am open to any...

I will give some details as to why I want to design the box like I am. I am going to mount the sub in the back of my Forrester which is 37" wide between the wheels. I want the box to occupy this whole space. I want to mount the sub in the middle of the box and have the face be atleast 27" as...

I really want 2 ports because I am going to mount the sub in the middle and have the box be symetrical. Any suggestions?

I am using WinISD to design a ported box. I want two ports, one on each side of the box so it's symetrical. My dimensions of the port are going to be 13.5"(.343m)x4"(.102m). When I tell it I want 2 vents, it says the length needs to be 18.197ft. That is abusurdley wrong. If I say one port...

My 2001 Forester has a spot where it looks like a tweeter would go but there is just a couple wires behind it attached to a black thing. Can anyone tell me what these wires do? Can I remove them or relocate them to put my tweeters there? Also, is this spot deep enough for a tweeter? I plan...

http://www.ascendantaudio.com/

I think I will probably go with 8s. Would you recomend: 4 RE RE 8"s 2 or 3 Crystal CMP8's 2 SS rl-i8's

isn't it 2.333 cuft? Also, would it be possible to run ports externally like this | |.........| | | |.........| | | |------| | | ........... | | ........... | |________| Does that make sense? Rather than having the ports outside the box, have them start coming out from the box.

I am looking to build a ported box with max internal dimensions of 36"x7"x16". I know this is small but this is the maximum amount of trunk space I can give up. Can I build a ported box this skinny or should I go sealed? What sub or subs would you recomend for this setup that cost around $300...