Recent content by CoreGMRConMan

series or parallel?

bump..

I just received an email from Memphis about this. Let's see; two M3122D subs wired in series-parallel would equal a 2 ohm total load- that's not enough power. two M3122D subs wired in parallel would equal a 0.5 ohm total load- that's too low of an impedance for your amp to handle.   If you keep...

Hello. I have a Memphis PR1000:1 powering a M3122D. Can I add another M3122D and not have any power issues or blow my subs? Will it sound better?

I just got the DPX 701 for christmas and am tying to set it up. I have a Kicker 350.4 amp running my speakers and a Memphis 1000.1 running my sub. Everytime i adjust my speaker amps gain, nothing happens at all. It stays static on sound. I then disabled the decks amp. Turned internal amp to off...

I just got the DPX 701 for christmas and am tying to set it up. I have a Kicker 350.4 amp running my speakers and a Memphis 1000.1 running my sub. Everytime i adjust my speaker amps gain, nothing happens at all. It stays static on sound. I then disabled the decks amp. Turned internal amp to off...

bump

still have the eclipse amp?

Got a PR 1000.1 memphis amp Got a M3122D 400 continous RMS I wired it at 1 ohm and turned the gain low. I then measured my amp with a test tone and voltometer. the voltomoter said the amp was pushing 20 volts at low. I thought that sounded high for volts at low. i then pushed the gain up a...

i want this... ygpm