Recent content by cocoleveo7686

  1. C

    lpf at amp or headunit or both?

    ok so does that mean If im going to use the one at the headunit I set the lpf on the amp all the way up? 80 or 100hz for sub?
  2. C

    lpf at amp or headunit or both?

    If I set my lpf on headunit (kenwood ddx773bh) to 80hz, should I have the lpf on the amp set to 80 or have it WIDE OPEN? or should I have it set on THROUGH on the headunit and try to set it as close to 80hz at the amp as possible. or do I set both to 80hz at close as possible?
  3. C

    RF T2 15 need help

    When I had my 12" T2 I had it on a hifonics bxi2006d and it took it all day. Obv not 2k power but it took it like a champ
  4. C

    how to set time alignment Kenwood dnx773bh

    I know what pink noise is but what is mono pink noise?
  5. C

    clamp 6-7k electrical?

    I would have to look at what he said. I think he said it will charge at idle just very low. Obv id want it higher. But what is the highest idle id want daily? Say I can get it bumped up to 750 would that be enough to get the same output as my 270a does? the control module is almost like an...
  6. C

    how to set time alignment Kenwood dnx773bh

    so if I measure I measure from my drivers seat to each speaker?
  7. C

    clamp 6-7k electrical?

    I have a 6 phase hairpin 270 in there now.
  8. C

    clamp 6-7k electrical?

    whats the difference between a 6 phase and 7 phase? Singer said next from my 270 is a 370. I actually had asked about a 320 and he said next step is 370. Would I even notice a huge difference going to a 320 from a 270? Doesn't seem worth it. right now im on a 5k wired to 1 ohm. Rising to...
  9. C

    amp for 2 dc level 6 15s?

    No I was running 2 12s and got 2 15s instead. I have my 5k right now and only got 2700 out of it rising to 2.4 ohms. So if I get an 8.5k and use the 15s. That will be TRIPLE the power im at now, plus going from 12s to 15s. I should see a 6db gain if not more... I did a 146.3 at 36hz. I can...
  10. C

    clamp 6-7k electrical?

    yes but I have been told the 370 runs nearly nothing at idle until you rev over 1000. I have a 270a singer right now, id just have him recase if I was going to do it. Unless anyone knows where to get a dual alt bracket for a 2013 Jeep Grand Cherokee 3.6L
  11. C

    amp for 2 dc level 6 15s?

    I have a 270a alt right now, Know anywhere that sells a dual alt bracket for a 2013 Grand Cherokee 3.6L? If not then 270a is prob the highest ill go. I can do 370 and singer said it will turn on at idle but this is my daily driver
  12. C

    clamp 6-7k electrical?

    Right now I have a 270a alt and 3 d3100 and a d3400 up front. Im wondering what else ill need to demo and not drop below 12.6 for clamping 6k. I don't believe a 2nd alt is possible on my vehicle unless I lose ac. I was thinking of going to a 370a alt but this is daily driven. What pros and...
  13. C

    amp for 2 dc level 6 15s?

    like 5 g31? I clamped 2700 so far and I don't drop below 13.5   ---------- Post added at 02:20 PM ---------- Previous post was at 02:19 PM ----------   I believe the 12k is only 1 ohm not 2 ohm. id have to get 2 ohm if I ran 1 Brazilian amp.
Top