Recent content by Chrismass

  1. C

    Need help, Amplifier in protection mode

    Well I hurt my finger today so I won't be typing too much. It was found to be the grounding which was the problem setting it into protection mode. This I had previously thought to be impossible because without a ground no electric would have been transferred, but I guess I was wrong. An...
  2. C

    Need help, Amplifier in protection mode

    Alright, that would make sense if the amplifier is dead or something wrong. I'll report back when I know the result!
  3. C

    Need help, Amplifier in protection mode

    I tried that, and it didn't succeed either. Here is my current setup. 8 gauge wire attached to the + battery terminal. http://imageshack.us/photo/my-images/28/batteryka.jpg/ Fuse attached to about 9 inches of 8 gauge wire. http://imageshack.us/photo/my-images/51/batteryfuse.jpg/ The...
  4. C

    Need help, Amplifier in protection mode

    Lanzar Car Audio That's the Amplifier, and this is the Sub woofer Kicker 10C124 Comp 12" 4-ohm subwoofer at Crutchfield.com I don't know if this helps but when I disconnect the RCA cables the light goes off completely, neither green or red. It only turns on red even if I plug in ONE of the RCA...
  5. C

    Need help, Amplifier in protection mode

    Okay so I'll start from the beginning, with the first statement being that I do not have a lot of money to spend on my system, thus why I went the inexpensive route. So I started off by purchasing for my 2002 Ford Explorer a Sony Stereo (Model# CDX-GT540UI) and had it installed there. Next I...
Top