Recent content by chickenhunter

thankyou mucho

Im just about done installing my new HU in my '68 plymouth so before i mess anything up i'd like to know - is this a good ground? (picture loading)

The 68 plymouth fury had an AM solid state radio in it - that's it

hey - im a first time installer and i wanted to know if anyone couls help me choosing an amp for my new sub. my electrical theory is a bit rusty so anyway - my sub is a Infinity Kappa Perfect 12.1D 350Watts RMS (175W per coil i guess) so what is the best amp for this and how should i wire it?

i heard somewhere that i could just twist the Power and the ACC leads together... is this a good idea?

anyone else have ideas of what to do with the wire for the ignition?

i've finnaly recived all my components for my first system: Pioneer DEH-P840MP Premier H/U Infinity Kappa 6" fronts Kappa 6x9 rears a Kappa perfect 12.1 dvc sub (whose amp still has to be figured out) anyway - my question is this: i am installing this stereo into a 1968 Plymouth Fury...

i've finnaly recived all my components for my first system: Pioneer DEH-P840MP Premier H/U Infinity Kappa 6" fronts Kappa 6x9 rears a Kappa perfect 12.1 dvc sub (whose amp still has to be figured out) anyway - my question is this: i am installing this stereo into a 1968 Plymouth Fury...

im dropping in a decent sound system in my old 1968 plymouth fury but to power it all i figured i needed about a 90 amp alternator (i think it has about 30 amps now). so i went down to the local auto parts place and asked for one and they said the highest i could get for my engine (straight 6)...

Ok so there's very mixed opinions on hooking up the DVC sub. here are the Sub/amp stats again: Infinity Kappa Perfect 12.1D Woofer Sensitivity (2.83V @ 1m) : 96 dB (IN-CAR @ 40 Hz) Power Handling: 350w rms (1,400w Peak) Frequency Response: 18 ~ 150 Hz Nominal Independance: 4 Ohms (per...

most of the good one's i've seen come from the UK which i can only find in one magazine store called Global Ink in NYC. Anyway, if you can find it Car Audio & Electronics is one and i can't remember the other - Total Car Audio maybe?

Yes - it's a single 12" sub and the Amp is a MTX Thunder 6152.

Independance per coil is 4 Ohms on the DVC Infinity Kappa Perfect 12.1D sub and it says in the amp's booklet... 37.5 watts x 2 into a 4 Ohm load with less than 0.1% Thd+N 75 watts x2 into a 2 Ohm load with less than 0.1% Thd+N 150 watts briged into a 4 Ohm load with less than 0.1% Thd+N and...

hello all - i have a dvc sub and a 2 channel brigable amp and i was wondering what people's opinions on how to connect the two are. should i connect one coil to each channel, bridge the two channels and hook them to the coils in series, or bridge the two and hook them to the coils in paralel?

i want to get a sealed box that has about 1ft cu volume