Recent content by cgorman21

Its turning off when it is very very low. Barely audible.

Thanks guys, all the fuses look fine. I'm not sure if it is going into protection mode, the LED is steady blue as normal, not blinking at all. The wiring worked fine for a few months. They are ran parallel for a 2 ohm load, the amp is 2 ohm stable. What settings would be causing clipping...

I have an Alpine CDE143BT head unit, a Rockford Fosgate P400-4 4 channel amp running four speakers, and an Alpine mrp-m450 mono amp powering 2 8" JBL GTO804 (4 ohm SVC) subs. The subs are wired parallel at 2 ohms. The whole system worked great until a few days ago, now about 90% of the time...

Thats what I thought. Did a little research, looking at mono amps 400-600 rms that run at 2 ohms. Am I on the right track?

Also, i only have 2 pre amp rca outs, how would i got about connecting two amps with 3 sets of inputs?

Thanks for your help guys. If I get another amp for just the subs and use the RF for both sets of speakers what should I be looking for as far as power/specs? I appreciate the advice.

I don't know how to delete the other one, started a new thread as you suggested. Sorry I am new here, just looking for a little help.

sorry new to this obviously. how do i delete that post, just started a new one.

sorry new to this obviously. how do i delete that post, just started a new one.

I have an Alpine CDE143BT head unit, a Rockford Fosgate P400-4 4 channel amp, and 2 8" JBL GTO804 (4 ohm) subs. I have a set of speakers wired to the front channels. I bridged the rear for the subs. I connect the positive and negative from the bridged ports on the amp to the positive and...

I have an Alpine CDE143BT head unit, a Rockford Fosgate P400-4 4 channel amp, and 2 8" JBL GTO804 (4 ohm) subs. I have a set of speakers wired to the front channels. I bridged the rear for the subs. I connect the positive and negative from the bridged ports on the amp to the positive and...