Recent content by Caveman Mike

Is it still available?

Is there a difference in sound quality or performance if I was to use one with 4 preamp outputs.

I don't really know a lot about head units. What is the difference between having a head unit with 2 preamp outputs vs 4? I'm running the head unit to a 4 channel amp if that matters.

I have noticed that my radio stations dont come in as good either but i made sure my antenna is connected the way it was before.

I ran wires from the rcas in the back of the hu and grounded it to one the screws on the hu. The noise is gone. My hu is a kenwood. I never had a problem with engine noise before the remote wire melted. I have since put in a new amp, remote wire, power wire, ground wire and front speakers.

I connected wire from one set of rcas and where they connect which is connect to a cord going into the hu. The engine noise goes away. What does that mean? Are my rcas bad or is it my hu?

I replaced the remote wire and i do get power to the amp now.

I had a melted remote wire at my amp. I ended up chaging it because it was bad. I replaced the amp also. Could the remote wire have cause damage to my head unit?

I have a sound like scratching when the engine is not on too. Im starting to think something is wrong with my stereo. My last amp had a burn spot where the remote wire went into it and my remote wire ended up being bad. Could that have caused damage to my stereo? Im not sure how to check though.

I replaced one set of rcas with stingers but the other set is a cheap set. Im not sure what u mean by running the speakers in the opposite direction? I have only done basic car audio stuff.

I just installed a new amp under my seat in my jeep wrangler. I'm getting engine whine through the speakers now. I think my ground is good but the amp is touching the metal of the car seat. Is there anything that is thin that i could use to insulate it? Am i right to think that the amp touching...

I figured it out. My remote wire was bad.

Not getting power to the power cable to my amp.

I am not getting power to my amp. I put in new power cable with fuze cover because i wasnt getting a current to my amp. I checked all the fuzes in the glove box and under the hood. They are all good. The inline fuze is good too. Any help or suggetions would be be much appriciated. It is on a...

Thanks mylows. Im sure it will be way better then the jensen amp that I use to have. I have read some good things about the mb quart amps and Im on a limited budget.