Recent content by carlos18

well it says."Caution:these amplifiers are not recommended for impendance below 1ohm or 2ohm per bridged (strapped) amplifier pairs. what does that mean? can it take a 2ohm bridge?

so should i change my subs?

i just picked up a t10001bd amp, and 2 type-r 12's(dvc-2ohms). i am still kinda new to this. i was going to bridge them and wire them at a 2ohm load. as i was reading the owners manual for the amp, it said its not recommended to do a 2ohms brige. will the amp be ok? has anybody had problems...

ok guys, thanks i didnt know that.

will it be ok, if i wire them to each channel, i end up with a 2ohm load with 115rms. the speakers power handle 100rms, and 300max. will that be ok, they will only be used for highs

hello everybody, i am just learning about car audio so dont be to harsh on me. First, i got 4 SPR-17C 6.5 alpine type-R, and i want to power them with my p.450 4channel RF amp. the amps maw power is 1752, and rms is 584. How do i wire them so i wont blow them?