Recent content by C..A.R...AU:DI0

oh okay. thanks a lot man! yeah, i was looking it up and found the jl audio wiring diagrams...it helps a lot, thanks again.

Do you happen to have a picture of how to do this? I have 2 elemental k's, but i dont think they are wired like you described for the 1200 watts (i have a jbl 1200). Also, what is a jumper cable, and where can i get one? THanks a lot man

Well, it's time to port the subs. I need the help of your car audio GURU's I have: (2) e10k's dual 4 ohm (1) JBL 1200.1 amp (2)Sealed Enclosures - .64 cuft. after displacement of the sub I know I need a subsonic filter if I do this...but what else do I need? Will I need PVC for the port...

thank you much. i found it under automotive radio and sales in the phone book. now th decide which one to go to!

I want to find a good car audio shop in my area. I looked in the phone book in "audio", "sound", and other similar things. I just can't seem to find any local car shops. I live in PA, about 10 - 15 minutes from philadelphia. Any suggestions on what to look for in the phone book, or any...

sounds good, thanks... *note to self...never get a pioneer amp from your dad even at a cheap price:banghead:

it just suddenly shuts off for like 3 seconds and then goes back on...then later on if kept at the same volume, it will do the same thing. It doesnt distort at all though, well, not noticably. How can I stop clipping? Or is it this way for good? Thanks

Yeah, I was going to check the wiring. It kind of does it more now, so the might be loose, but both of them? Also, how is it the amp could be the problem? I can see where you are coming from though. It's a brand new amp giving the components perfects RMS rating and all...I don't think it's...

Hey all, I have a question for you that I haven't seen before anywhere. I have a pair of Crystal Csc50t components. When they are at a high volume, they just turn off for about 3 or so seconds. They are ran off of a pioneer Gm-X364 amplifier in just 2 of the 4 channels. The gains are set at...

Hey, how should I wire these subs to get the full potential out of them and my amp? I hear that with the stuff I have, I can get a final 1 ohm load and get about 600 watts per subwoofer if I wire it in parallel. 2 e10k's (4 ohm) Subwoofers 1 JBL BP 1200.1 Amplifier...

Hey everyone... I came tonight to ask a wiring question that I think is affecting the performance on my truck subs... I have a pickup with (2) e10dk4's (4 ohm) and (1) JBL 1200.1 amp. I'm not happy with as loud as it can get, I have it up to 30 (max volume) on my pioneer HU, and it doesn't...