Recent content by Breaker

People that do dash generally don't do good outlaw. Just tuning higher helps the sealed scores. Tuning lower helps the hear rest scores. Comparing a system meant to be outlaw vs a system meant to be sealed up is not valid.

It will be ok for dynamic songs but anything bass heavy just watch it close until you get a feel for it

Run it at .5 keep 13.5 at the amp put a fan on it don't clip it excessively and you should be fine. I'm not sure how reliable they will be but get one from a good dealer. Remember the amp is 6kw with a regulated power supply id expect around 75% efficiency real world with a soft clip. So your...

Honestly if I wanted a fat box I'd do a 4 to 1 6th order. The ported box with a loading baffel s meters well and still sounds good. I can control the mechanical damping without adding group delay with the second 4tg order. Essentially it's a tad more punchy without the delay. 😍 It won't peak...

That's what the loading panel does. Still haven't tested yet I was having trouble with my dual alts and the pwm controller charging. Then my ac went out. I have a slow leak on a weld on the EVAP common problem of shitty Chevys. If I do decide to do a 6th I'll have to wall it and I'll do 3 18s in...

Yea 160 with this power in a wall is a must or you gotta throw it away. My last setup clipped 7500 with two 9915s and did 158s

I have nothing on the roof. I'm limited to deadner which might hurt my score but seeing as the entire roofs broken I think it might help a-tad just from the nasty resonance I'm getting and flexing. I'm reconing the drivers to dual 1.4s so I expect to do 158s at the least. I think I'll be ok...

The loading panel is typically two inches above the face of the box. Just enough to allow the woofers room for movement. It brings the impedance down by loading the woofers

Ran a bass 8k at .25. it did like most other amps at .25. keep it in it's wheel house and don't clip it it was ok outside of that red light special. Lol

Yea I'm tempted but honestly a few tweeks like a loading panel and reinforcing the roof I'll be doing 157s no doubt. I did 156s with my one 370 dropping to 13 and my stock alt and 370 was noticably louder on music. I'll probably recone to dual 2s and it should be pretty close to 160 and daily...

Don't have to room if I do I'll do an ABC alignment

Fuckbthem yinglong. If you want lto lishen holds better above 15 and has a tad better discharge. They have much more powerful cells I'd use than yinglong

Anyone burp a bass 30k at .25? Got two 370s and a 160 yinglong. 156.2 rising to 4.2 clamping right around 7500. I can easily dump another 15k for burps at my peak but that rise is Killin me 160 no wall is the goal. Should be easy once the roof is fixed and the space around the box is sealed off...

The distance from the subs to the hatch to the subs is directly cancelling in the bandwidth. The reflected wave is cancelling the original wave. Hence when he opens it the cancellation goes away. Move the subs 4-8 inches from the hatch and it will sound better.

Cancellation. It's not acting like a bp. It's just cancellation. Put the woofers closer to the rear hatch