Recent content by brad2005

just checked again and one is around .750 and other tweeter is i think 3.2

yea i did and it wasn't reading 3.6 ohms or around that like i think it was supposed to, it was reading low just cant remember exactly how low.

yea i set gains with dmm today. They weren't distorting or clipping before though. Anyone know about using another set of decent 4 ohm tweets on the pg crossovers be ok? or know how audiosavings.com is about warranty? Thanks

well im pretty sure i've got it fixed. I just went back and rewired it and unbridged it so i have rear fill now. Only problem is now my tweeters aren't working so i guess they are blown. I tried a tweeter i just had laying around on pass. side and it worked so i know its not the crossover...

ok nevermind i tried that and went and drove around and it seemed better for a while but then it did it again, so i cut off hu and cut it back on and went down 2 on the volume and it would stay on so im thinkin it is maybe the gain. But i had the gain up more when they weren't bridged and had no...

also i just thought about it, I've got a switch for each set of channels front and rear that is for mono. If i turned this back on would it fix it? I think that could be whats wrong. Thanks again.

i looked on the eclipse fujitsu-ten website or whatever and it was showing that it was 4 ohm stable putting 150 wrms x 2. Maybe i looked something up wrong but im pretty sure thats what i read. Id like to get this amp working but i might just end up getting another decent cheap amp like the...

no im pretty sure the ea4000 runs at 4 ohm bridged. I may be mistaking but im pretty sure it is. I fixed the grounds today to where i know they couldn't be any better. It's weird but the amp will just all the sudden cut off randomly, seems like around maybe every 20 mins so its not like its on...

Ok I just installed phoenix gold rsd6.5cs in my front doors. I ditched the rear fill and bridged the amp for the 2 front components. The amp is a eclipse ea4000. It was originally ran off 4 channels for front and rear speakers. The problem didnt start happening until i installed components and...

Id give you 120 shipped to 29302.

Ok, I've got a very small convertible, and i had my system installed a while back at tweeter and they measured the trunk for my sub's and box and said that there wouldnt be enough airspace for the subs so they built a sealed enclosure and put them in the backseat firing up. When i used to have...

Anyone know if you can download the wallpapers from i-personalize onto the IVA-D300 ? I saw that it said you could download them to the IVA-D310 but i didnt know about the 300. thanks in advance brad

Does it have a faceplate that you can remove? I used to have an old xplod headunit and it would beep letting you know that you had not removed your faceplate. let me know if this is the case.

i checked the grounds and they seem to be fine. Im not having any serious voltage drops but my alternator probably is getting weak because its only 70 amp. The subs aren't sounding quite right whenever they do play, not as loud and def. not as clear, they seem 2 be fluttering. I dont think...

no the amps aren't going into protection. the subs are wired parallel 4 ohms i think. thanks 4 the reply.