Recent content by Bommy

I hooked up an old class A amp I had in my room and it works perfectly. I'm starting to suspect that my Phoenix Gold 200.4 took a shit on me..... ****it....

I cut the grounding wire in half. I unplugged all the speakers and tested each one in a different channel and it still plays fine for a little while then a loud screeching noise. I'm starting to believe it is the amplifier. I have another amp in my room i am going to test. I'll let you guys...

Okay, I took apart my system. I unplugged all RCAs and still the loud screeching noise gets to the speakers. This leads me to believe it is with the amplifier.

I was driving today listening to my ipod on my alpine cda-9887 (everything sounds great) then all of a sudden I get like a screeching noise. This happens on all sources (radio, cd, ipod). I was surprised at first, so i shut the unit off and then turned it back on. The noise sounds like when...

Will do.

I recently got everything installed in my car. If i'm listening to music at a fairly loud volume, it sounds like my front tweeters and mids suddenly decrease in volume. I have to lower the volume and then raise it again until it happens once more. I'm not clipping the speakers, they never...

I'm using 2 independent channels for the Dynaudio 160GTs on the Xenon200.4. I am bridging the both the RSD65cs speakers on the remaining channels on the 200.4 to make 1 channel. Everything is active. I am taking all the passive crossovers off all the speakers. I am using a separate amp for...

I have looked at the manual and I have an idea about what I'm going to do for my system that I'm putting in the car but I would like the advice of the more knowledgeable car audio folks on this forum. I plan on having Dynaudio MW 160 GT on the front stage powered by a Xenon 200.4. The Dynaudio...

Might be because the new HU outputs at a lower voltage. Try using a line driver to get your channel output to around 5-8v. 8v is the highest the PG amp can handle I believe.

bumpage

I have a Toyota 2002 Celica GT and according to crutchfield a set of Boston Acoustics Pro60 will not fit in my car. This is unfortunate because I don't know of any other set of speakers that will handle 400watts/channel from a bridged Phoenix Gold 200.4. Is there a set of speakers than can...

So far I have the following: Pheonix Gold 200.4 Amp Pheonix Gold 600.1 Amp Alpine 9887 JL 12W6s X 2 According to crutchfield the Boston Acoustics Pro50s will fit in the Celica. I would like to run everything active. I was planning on just running 2 fronts and 2 tweeters if possible. I'm...

I plan on upgrading the entire system in the next car I buy (probably a Volkswagon Jetta deisel) and i'm trying to save money where I can. I was wondering if I buy an Alpine CDA-9887 will I have to install an active crossover if I want to seperate my lows/mids/highs? I don't want to keep the...

http://www.rockfordfosgate.com/products/ez2rockford/ModelInfo/ModelInfo.asp?ItemKey=10063579&CategoryDesc=Punch%20Subwoofers for the specs

2 ohm sub i believe.. its currently runnin at 300w @ 2 ohm.