Recent content by Benihana

Yeah its a set of kicks/speakers that was built by Bing that I bought used from someone on my350z.com . I really like the dls speakers they are laid back and not harsh at all. I looked up the speakers and they seem to cost a fair bit of cash by themselves, so I think i got them at a steal. I...

Here is a simple system I put together for my Z. I bought some parts used and some new. I installed it by myself and cut up most of my fingers doing it, but well worth it in the end. Amps/wires are hidden in the cubby behind the seat, so don't mind the mess inside it Kenwood KDC-x994 hu...

I ended up getting the p3 10", very nice sounding sub, and plays fairly low. Thanks for the suggestion.

how bout an ED 11kv.2? Nice rice and small box requirements.

This is the enclosure I have, anything else wouldn't really fit, and I don't want to get ri of my spare.

i'm stuck with the box because it is kinda like a stealthbox, it would cost me more to get a new box than to get a new sub.

I found a p3d210 on ebay for $103 shipped. Looking at the specs, how can you tell how low a sub plays?

isn't the box too small to be ported?

yeah its sealed. Well its a prefab under strut enclosure made for this car so I cant port it. I prefer the sound of sealed as well.

I have a Alpine Type R SWR-1041D 10" in a .85cf box in a 350z, and it does not play low enough for me. Is there any other 10" sub around $100 that will play lower than this? I need it to be 4 ohms as well. I'm basically looking to have deep bass. thx.

I recently acquired an older RF Punch 100ix amp & Punch 200dsm amp for my system. I just can't decide which one I should use for components and sub. the 100ix will do 110x2 @ 4ohms, and 420x1 bridged @ 4ohm the 200dsm will do 150x2 @ 4 ohms, and 500x1 bridged @ 4ohm The components i'll be...