Recent content by beefy103

Any links to a site that tells you how to adjust all of these?

I just got my nine.1 and rl-p installed and was just wondering what to set all of the controls at to get started. There is the LPF, Sub Sonic, Bass Boost, Gain, and Phase. What should I leave down and what should I turn up or should I just put them all in the middle and go from there? Also...

I have an eD Nine.1 amplifier. If I were to run 3 wires would it sttill be a 2 ohm load and what would I do for a terminal?

Im now in the final stages of getting my setup up and running and had a couple last minute questions. So my rl-p is a dvc 4 and i know I have to wire the two postives together and the 2 negitives together into a 2 ohm load. My question is how exactly do I connect the two positives from each...

or will i absolutly need a bigger fuse will 80 do for now?

So will an 80 amp fuse be ok if I wanna be cheap?

For now the front and rear speakers are being powered by thr head unit. Im just going to get a cheap pair of alpines for $50 for the front and just throw some other speakers from who knows where in the back for now. Im not sure how long my cars gonna last so I'm not going to go crazy with...

What do you mean run the front stage off of?

I am buying a nine.1 to power my sub and am looking at wiring kits. I see that eD offers two types of 4 guage kits. One which comes with an 80 amp fuse and holder and one with a 150 amp fuse and holder. It says they both are recommended for the nine.1 so does it make a difference which one I...

What should I use to secure my sub to my box? I have an RL-p so its pretty heavy, will little screws just hold it to the box but ones that are short enough not to go through the mdf. Or should I do a bolt and have a washer and nut inside the box to hold it? Or t-nuts? What works?

I have my SS RL-p 12 and my eD Nine.1 is on its way and now i just need some wiring. I have been looking around for wiring kits but each one has something in it that wont work (like to small a fuse). Is there a 4 gauge wiring kit with a fuse over 100 amps that comes with rcas, turn on lead...

Any room for negotiation? I could do 250 shipped.

Im interested in the Nine.1, Does it still have its warranty?

So what size fuse would you recommend for a nine.1 hooked up to a 80 amp alternator? I heard knukonceptz has some good stuff. Would this work?http://www.knukonceptz.com/productDetail.cfm?prodID=KOL-AK4 If I got that could I upgrade the fuse to a higher rated one if its needed?

It's a 92' saab 900 and they are located on the dash.