Recent content by Beatin2door

Yeah save and buy once I think youll be a lot happier with better quality.

If you have all that to back up your next amp then I would save a little more money and buy something good like Sundown, Crescendo, AB Vfl, I was in the same boat not long ago and it took me a month to decide on an amp. I went with the Crescendo BC2000 because you can get a .5ohm warranty with...

Just keep it in mind that you may need electrical upgrades to run 2k, and that alone could end up costing you more than the amplifier will cost. If your going to keep the stock electrical I would really look at the S1500.1 from Crescendo they are very efficient something like 90%@2ohms and it...

If 300$ is your limit I would look at some good used amps. I cant really think of anything that will actually do 2k RMS on that budget. What kind of sub's are you using now? Also if your gonna run a 2k+ amp you will need some electrical upgrades to go with it. You could maybe check out the Apcl...

If you end up with 1.07 after sub i'd say you did a good job gettin the box as close as possible to spec roll with it.

No word on the 4th order yet. I got the overall diameter of the hdc3 15 and built a temporary baffle. i need both the subs and the port firing the same way. i want to build a slot port between the 2 subs but i can only get i max height of 14 7\8 and theres 7.5 inches left between the subs. What...

I'm not sure how well it will work but Lowes has 5 inch galvanized pipe for cheap. I'm gonna try the 7 inch for a project I'm doing.

I never thought about trying something like that. I'm gonna take your advice and do it. If all else fails I'll use my last idea lol. What happens if a sub needs to come out. I've seen pictures of 4 orders some of them with ports big enough to crawl into. I'm not gonna give up on this. Thanks...

I slid my old enclosure back in my trunk today its 11 cubes empty, anyway if I pull it out towards the cabin of the car 4 more inches I can port the top of the box and still have my sub's and ports firing into the cabin, and I cznstill easily seal it from the trunk. I was gonna try and build a...

I estimated my enclosure volume to be roughly 10.6 cubes before my port and sub's go in. This should give me close to 9 cubes I'm thinking after port and suabs. I estimated the displacement of each sub to .22 I couldn't find the actual displacement , and with a port measuring 14.875 tall 7.5wide...

Hmm yep I say off to the factory with it. I had a brz2400 I never had any problems with it. I played it full blast for 2 hours a day to and from work for a year it never even got hot during the summer.

Hey BigScott do you still have your hdc3.0 15? If so do you know the overall diameter of the subwoofer.

Yes sir 9 cubes in trunk just got rid of my 11 cube box outta there they slide in and out perfect after I took a grinder and cut a 39inch by 17 inch square hole behind the back seat I build them 38.5 wide and 16 3/8 inches tall so they don't get stuck going in I c an go up to 44 inches deep...

All the hifonics amps have a diagnostic mode that will shut down power until its reset. To do this unhook your RCA's ,and leave power ground and remote wire connected, now turn the amplifier back on, if the diagnostic led lights there's an internal fault wit the amp if not cut power plug rca...

Are you refering to the cutout diameter of the sub? I really need the overall outside diameter with mounting gasket. This way I can figure out how wide I'll be able to make the slot port between the subwoofers. I would fire the sub's up or back with port facing the rear of car, but when I tried...