Recent content by batmanjl

Hello, ive had the older model 16 x-03 in the past. was designed a bit differently. can anyone tell me how to bandpass this newer model? which HP acts as the lowpass, and the HP as the HP? 16-CX23 - Memphis 2/3-Way Active Crossover any insight is appreciated.

Most everything "added" I already had I a couple other cars. Added the three.1 for volume control on the fly. Added Memphis line driver to boost my subs amp and a tally replace the epic. I played with the Kenwood a while before adding the extra. Just couldn't get it right. I'll have to double...

Was thinking, i could run sub output into three.1 or to amp, and use lpf from HU and use HPF on amp to BP mids?

with no bass involved its "decent" till i crank the volume, then it sounds s****y. not sure if i need ot make cuts everywhere, or what. lpf for sub is set to about 80/90hz. Hpf is set to arounr 100/120. wether on X4R or headUnit, thats where i normally set it at. HU is on flat though. Doors are...

So just to be clear, the X4R only? lol. any suggestions on how to tune the Q factor?

parametric over graphic? in that scenario, using what i have available, should use the built in DSP on the X4R for mids/highs?

Hello All, looking for some advice on tuning my inside speakers. im aiming for SQL, as my trunk is purely SPL (lol). my current setup back to front is as follows: 2 12's tantrics in a 2:1 4th order box, on 1 3.5k Twisted sounds amp (currently doing 153.2 out the trunk) Blowthru. 2,4 channel...

means i have to keep the norm mojos (dual 4) since the mojo X's only come dual 2. unless i switched to like my DD m2a or m3a

define to much? lol the place i go to locally cuts me a deal, i paid what most people pay for 1 almost, for 2. but i do have a question for opinion. would you run the norm mojos 12 with the mojo 2200 amp i already have, at 1 ohm, or run the mojo X 12 and switch to the kicker kx 2400 @ 2ohms?

just for an update i switched to the mojos :/

Will be building a box over the weekend. Was thinking about was thinking about switching subs because these k9s bottom out :/ and think they might be slightly damaged from a burn smell but I've always smelled that since I got the subs. Will remove epic... should I use my line driver or no?

would the Sundown SA 12s hold up with this amp?

anyone had one of these amps? i have one pushing 2 k9 12s and it sounds "ok" but subs sound like they are bottoming out or to much excursion for lack of better term, the gain is literally a smidge up, a half a turn lower and it would be inexistent sound. any input oon tuning this amp? or would...

Your right it was sundown. And it's just preference to be local. Soon as I purchase I can just drop them in , and I have a buddy who has k9s and k6s in a couple of his cars, and doesn't have any issues but he's not pushing a lot of rms.

I tried to get the ssa 12s but no one had them locally. Only the 8s