Recent content by Basshead21

Hmmm I decided to run it at 0.5 ohms. What connectors do you guys use to go from your wires to the terminal cup? I am going to solder, and use wire wraps, but what connectors should I use? Spades rings, or knives?

The box is already built at a 34hz tune brahh.

I have a stock 100 amp alt, with a Autocraft gold 75-3 battery. There really is not room for a 2nd batt, but I understand if I have to I'll find room somehow. Here are the specs on my current battery. Group Size: 75 Voltage: 12 Cold Cranking Amps (CCA) @ 0°F: 700 Cranking Amps @ 32°F: 875...

Bump for someone trying to help out a noob.

Okay, I am going to get a performance alternator, upgrade to 0g wire, and get a performance battery. Should I get a D2 sub? Or should I just run this D1 @ 0.5 ohms? From what I have looked at stinger batteries, and alternators are the way to go. I really don't have any room for a second battery...

I am getting a performance alternator very soon, what amperage should I get to run this system? Also I did the big 3 already. My battery is about 4 months old, it is not a performance battery but I think it will do the job. Thanks for the input brah.

Anyone ever wired a single Audioque HDC3 15 to a AQ1200 using 1/2 ohm? Any opinions or personal experiences? I would really like to keep this sub if its possible.

****, if I could, I really would like to keep the AQ, but if not I guess I could find something else. I will be listening to rap, and high bass music. I would like to turn it up fairly high, I am just trying to get the best bass out of this setup.

I have a D1 sub.

I am a complete noob at ohms, and ohm loads. I just drilled a 3 inch hole for a 4 1/8 in terminal cup. So the HDC3 15 I have has two different sets of wires, positives and negatives. and my amp (AQ1200) has two positive and two negative ports. So basically my question is should I put the two...

I finished my first box today, and got it carpeted. I want to thank RAM_Designs once again for the design. I would recommend him to anyone who wants a legit, and affordable box design.

So the box will be done tomorrow, I bought 3 yards of charcoal felt. From what I have heard 3M spray adhesive is the way to go. Also, this did not occur to me until I was done where will I run the wires? Should I grab a 4 1/8 speaker terminal? Or just run them through the port?

Sorry for not updating lately. I took my box into my shop at school because I thought my woods teacher would know what to do. I have everything cut out and started gluing last week. I am not sure how I will carpet this big box though. How many yards of carpet do I need? What kind of carpet...

Ill invest in some clamps, AND use some screws.

Are clamps completely necessary? I was planning on putting the glue down, then screwing the boards together.