Recent content by barry_mann

i have already bought the 6.5 3 way speakers

another question. if i hook the 6.5 and 3.5 to the same channel on the amp and they are about 3' apart will one be alot louder than the other?

i have already bought the speakers. if i would have known about the 3.5 i would have went with componets. so hook them both up to the amp? and nothing to the head unit?

to leave the 3.5 hooked up i would have to scotchlok the rca converter inline. i am not sure what the wattage drop would be. actually if i knew that and the stock wattage of the front channels i would have my answer

i am installing a 6 channel amp, replcing door speakers and back dash speaker and adding a subwoofer. i just discovered i have 2 more 3.5" speakers that are wired into the front door speakers. i am not sure how to handle it. i have 2 options 1.) wire them to the amp along with the door...

so should i power all four of the front speakers with 2 channels from the amp or only the door speakers and use the stock head unit to power the 3.5's? most 3.5 speakers have very low rms wattage. so if i use the 2 channels to power the 4 speakers will the wattage be evenly divided or what will...

what part is about so i can explain better. the front 2 channels of the factory radio are powering four speakers.

I just found out i hsve 2 - 3.5" speakers in my dash. I figured i need to upgrade these along with everything else. well after further investigstion they are wired in with the door speakers. so i am not sure which route to go. should i wire the amp to the stock wiring and power them both up or...

I am fixing to install my system and i am needing a few things. 1.) 4 channel rca converter 2.) Amp kit 8 - 4 gauge 3.) and whatever else you can think of. i got the speakers and amps.

now the amp has changed. I had a very bad dealing with stompaudio.com. Anyway i ended up purchasing a Infinity 5761a which is a 6 channel and i think it will work out better than what i had.

i sent you a pm, let me know

The place i ordered my MTX th805 backed out on me. Said they were backordered indefenitly. I need a decent amp at a decent cost. I will be powering 2-40rms, 2-90rms and 1-400rms. The amp i ordered was a 5 channel. I am new to this and dont have too much left in my budget ( around $200) what...

I just bought a Q logic speaker box. it is pretty nice. they had it marked down at best buy from 129.99 to 49.99. It is for the single 12"

JH805 Amplifier Specifications Primary Ratings Power Output 37.5 Watts RMS x 4 Channels and 250 Watts RMS x 1 channel at 4 Ohms Signal-to-noise Ratio (1 Watt) 75db (Front/Rear) 70db (Sub) Secondary Ratings Power Output 75 Watts RMS x 4 Channels and 500 Watts RMS x 1 channel at 2 Ohms...

so bridge the front 2 channel and bridge the back 2 channels. Now the sub is a 4 ohm to. what can i do about that or should i just live with it? Also couldnt i just bridge the 6x9's and leave the 6.5 as normal? Or would that be bad?