Recent content by Badseed

I currently have 2 sa12's in a prefab box. I really dig them. Another just popped up locally for 100 bucks and I'll probably end up snagging it. What would a good box be for 3 of these? I've read that they can handle small enclosures better than some, but I'm guessing this would still be a...

Thanks for all the excellent info man. So basically the problem lies solely in the stock deck. My wiring harness will be here early next week and I have a mid 2000's pioneer or alpine deck to choose from on hand to install for now, so hopefully that solves the problem As for the rest tone, I...

So, the loc could be sending a clip signal if turned up too far?

Whoops, didn't see the quote in your post. My bad

No, I called around to my local shops and none of them have one (which seems crazy). I also don't know anyone with a scope as none of my friends are really into car audio, so I'm kinda out of luck on that one. I'll buy one eventually, but not in the cards right now

Haha. I have a general idea of what I'm doing. Know the basics, but that's about it. My box is prefab, 3.5 cubic feet @35hz. The subs got plenty loud on the hifonics and those amps are generally overrated. I'm not sure why the MOSFETs fried on it. The amp never got more than lukewarm and I...

Bass boost on amp is never on. No bass boost on stock deck eiter

Currently running a kinetik 1800 up front and 2 2000's in the trunk. Big 3, 110 amp stock Alt. All knu konceptz ofc 0 guage throughout

Unfortunately no, I got the amp used and it didn't come with it. I went to order one and they're on backorder still. I've read from a few different places that they're not as accurate because they work on rail voltage? I'm.not going to pretend I know what that is but I just read that people...

Long story short, I was running a hifonics colossus on my 2 Sundown sa12's for around 3 weeks and last weekend, a couple of the MOSFETs fried so its getting repaired. I had an aq2200 on hand that's going in my second car soon, so I installed it so I could still have some bass while the hifonics...

I'm.starting to agree. He still hasn't replied to my.pm from yesterday either.

Pm'd

It was around 2.1 after it settled. I measured the subs and they still measured at 3.53 - 2.1 means they're at 1.4 ohms in the box Thanks for the tip, I was not told that you have to subtract the resistance of the meter. Now I know!

I believe so. Letting the glue on the spider pacl cure until tomorrow before I give it a run through.

Never implied that it was. Just stated the way I was shown to do it, and stated that I wasn't sure if it was correct or not.