Recent content by Aruman

Isn't the lvl 4 only for ported enclosure?

What about the Mach 5 Audio IXL? they are cheap, and I've heard good things about them.

The one on the left is the old logo.

Has anyone heard the new *** already and how they compare with the old SE's and good luck with the sale

Hey Jacob, how these subs compares with the RE SE's?

That's a very nice Subs, it's worth the wait, and a very nice logo. Is it for ported only like the SX or can be sealed also?

No, not 100% competing, but very loud on music. for Electrical, now i have 1x Ohio 230a Alt, as for batteries 1x PM D5100 front, and 2x PM D3100 in the back, and 3 runs of Power and 3 runs of Neg. 1/0 KnuKonceptz if I switch to the MT's I'll put one more 230a Alt. and the batteries and runs...

OK guys here's the question, will it be a big difference on the meter and by ear going from 4x RE SX 12" (powered by 2x USAmps MD-3D in an 7 ft^3 tuned at 34Hz) to 4x RE MT 12" in the same box and tuning but power by (4x MD-3D thus one Amp per MT's) I assume the MT is similar to the BTL's and...

Ok guys I have a question, currently I'm working on my car I'm about to install my new Audio system which consist of 4x RE SX 12" d4 in a 6.8- 7.2 ft^3 enclosure tuned at 34hz powered by 2x US Amps MD-3D and for vocals I have 4x Sets of the RE 6.5 Comps thus a total of 8x RE 6.5 Speakers...

Come on guys, no need to insult each other, why every time there's fighting? now back on the type r vs SX, TommyK in what box was your SX and Type R, tuning and power? was it a direct swap or an enclosure build for each subs? the reason i ask is i recently bought some SX and so if the type r...

ok thanks, I've just seen the one on SSA forums, now for wiring the subs in the box PIC 1 (link below)should be the best way to wiring them? If I wired them this way will each amp see 1 ohm automatically thus producing it's rated 2000wrms, thus using one lead wire for positive (master)and one...

ok, thanks guys, R/T Pimp do you have a drawing of this so i can see it better what you mean, thanks.

Hi, I'm Aruman and I'm new on this forum and have some questions. The problems is that I'm a bit confuse how to Wiring two US Amps MD-3D Using the MLT Wiring as shown in the Owner manual( pics,link below)The problem is that the owners manual says the lowest Impedance is 4ohm, so that means...