Recent content by anybodykilla200

its the old shredder so i heard its not good to put them at 1-ohm? also if i do i heard that theres somthing on the inside you should do is that true? i had to replace the fuse already on the inside

alright i would first like to state that the one and only reason im selling these subs is because i need a pair of dual 2-ohm subs so my amp can be fully utilized, i have the PHD2 and i need to get a 2-ohm load, these subs are 2 months old and have notthing wrong with them there amazing subs and...

which shredder is 1-ohm stable the new ones or the old ones?

its funny cuz i went and opened up after i got done writing the post and it said 30 amp fuse but there was a pooped 20 inside so i replaced it with a 30 cuz thats what the amp said, but what did you mean by good signal path you said it in a way that sounds like you know somthing i dont if so...

alright check this out, i just hooked up all my new stuff yesterday and no sound comes out, i checked everything and rewired everything and my amp turns on as well as everything else in my trunk(bass cube, crossover, cap) and i have a good connection with the amp and the subs as well, if it...

aright im trying to wire my pair of Audiobahn AW1200Q's to make my amp see a 4-ohm load, now the subs are dual 4-ohm but the problem im having is that there are 8 terminals on each sub, theres 2 neg.s on both sides and 2 positives on each side now i know why the extras are there its so that...

where can i get the enclousure specs for a pair of a pair of Audiobahn AW1500X's?and they dont have them at audiobahnic.com) please help.

im going to use my audiobahn hcx 2200 for now, but im lookin for a more powerfull amp. the guys over at audiobahn said that 400 watts to each sub is just as good as 700 i don't know how but i trust them. my amp puts out 1600 watts at 1 ohm so it'll be nice cuz im getting 2 of the for first so...

I've decided that im gonna get 4 audiobahn AW1200X's there gonna like hell but thanks again

alright so i'm threw with sound quality i need to start thumpin so which would be louder: 4 12inch rockford punch hx2 dual 2 ohm voice coil so they would see a 1ohm mono load on my amp giving each sub 400 watts each or 4 12 inch kicker compvr's dual 2ohm voice coil and as stated above each sub...

alright after some research (which ****** up most of my week) if come to the conclusion that i want three 12's and im sick of my 3 perfects so im sellin the 3 for 260 and gettin a new set of 12's alright anyway which set out of the three do yo guys know from hearing or know cuz you just do which...

alright well i took your advise and got'em wired up and it said that it would be a 1.36 ohm load!?! what the hell does that mean? what would best describe this load with my amp 1ohm mono 1ohm stereo 2ohm mono 2 ohm stereo? which one? help!!

i was planning on using 3 rockford he2 12's hooked up to my audiobahn 2200hcx which at iohm mono puts out 1600 watts and 1ohm stereo puts out 1200, in terms of wirirng thats why im askin you guys cuz i need your help determining which confiquration to go with

what kinda loads can 3 dvc subs produce?

thanks alot im gonna give that a try i'll post how it works out, thanks again for the help