Recent content by androtaker

its best never to go universal (all speakers are different)

you acc -red and batt +-yellow wire are hooked up backwards

considering that is triple what most cars have itll be fine id throw a cap in for sh$ts and giggles though

its hooked up wrong it would be best to make your own power wires for it (for the ignition turn on wire just run it into a fuse on the fuse panel and dont worry about the dimmer wire

2 suggestions 1) crutchfield has a alternator noise filter that installs between you alternator and that wiring for the car 1) replace the alternator

actually all you need is like a 100 amp fuse and look on ebay they have great circuit breaker boxes that seem to work pretty good. and the 0 guage wire suto parts store some times has it or if you loom it you can use car audio wire for that

bridge it you dont want a voice coil moving at a different rate as the other one especially when there glued together, and yes

send the amp to me ill set it up and send it back.....just playing, the best way to learn is play around with it and figure it out you wont hurt the amp doing this its best to learn how to tune it on your own

without seeing your setup the only thing i can add is to cut the back of the pocket out with a dremel or whatever works and mount it in there

usually the orange\white wire is a dimmer wire

probably the wire ( if you installed it try rerouting the wire and check it for cuts last thing is buy a replacement and swap it in if it doesnt work then bring the wire back. if there are rca plugs that attatch also be sure to make sure the negitive or outer shielding isnt touching ground

not really sure how that works but I think that you will probably find that the smaller wires are for the highs and the larger guage is for the mids and lows there shouldnt be any negative effects to hooking both wires together (p to p and neg to neg ) of course. I say shouldnt be any negative...

head units are getting more volitile do to all the stuff crammed into them so you probably messed up the head unit by doing this usually bass only and no hi's = hu

youve got it all figured out go get er done most prefer 65hz voice doesnt start to bleed through too much until you reach around 80hz

make the xm its own ground(chasis ground) shorten the wire make sure the xm box isnt near any computers or modules