Recent content by androidsixseven

Thanks, yeah I'm using them in parallel with a crossover. I'll check my grounds..could be the impedance. thanks

When I turn up the volume on my deck, the amp for the highs and mids shuts off. It get's hot enough to burn skin. Could it be the wiring of my components ? I have the front mid and highs on the left channel and the back mid and highs on the right channel of the amp. The amp is a Kenwood...

Hi, I need some help or opinions what to do to correct this problem I have. I've got a Kenwood 1000w bridgable amp, hooked it up to the front speakers (Kenwood excelon highs and mids with x-over) and regular Kenwood components in the back as well. I hooked the fronts up to the left channel of...

If I were to purchase two 1000/1 I think a new altenator or a rewinding would be in effect .... capacitors would not solve this problem

I'm using a JL 1000/1 amp and a 12w7. I was wondering if I hook up another w7 and bridge the two subs together. Would the spl increase because of surface area, stay the same because of half of the wattages are going to two separate speakers or even decrease because of a lack of wattage per...

I have the x969 and let me tell you the deck is hella awesome ! I had the mp919 before that and this one pretty much tops it. Adjustable display and keyboard, angles in and out up and down, graphics are top notch as well as the srs wow and the processors in there. Best money I have ever spent...

Using a 12w7 and a JL 1000/1 amp , would a 150A circuit breaker have a too high of an amperage on 4awg wiring throughout the whole system and have the possibility to fry my amp? Thanks

I am running a Jl 12w7 and a JL 1000/1, inline from the battery with 4awg wiring through the whole system. I am using a 100A circuit breaker going from my battery to the 1000/1 and it keeps clicking off when I play my music 3/4 to the max volume. I have already dialed in the correct output...

Still contemplating on the JL 1000/1 , just wanted some insight on any other amps out there that might be comperable. Thanks!

Thanks for the replies...hmm well I do have my mind set on the JL 1000/1 for sure but is there anything else to bring the 12w7 to full operation for anything lower or same price as the JL amp? Thanks

I presently have a Kenwood KAC-X8910d running around 600 watts at 3 ohms. (The amp can run at 4ohms.400 / 2ohms.800 / 1ohm.1600) I was wondering which would be better for an upgrade. A......... ALPINE MRV-1507 1500w max @4ohms: (cheaper, internal fan, 105s/n ratio or JL AUDIO 1000/1 1000w...

thanks for the comments! will try looking around for amps

http://www.kenwoodusa.com/product/product.jsp?productTypeId=11&sortBy=price&productId=2424 It says it can be mono or stereo......Hmmm ? But yeah I'll see what happens, thanks for the posts!

I'm getting a 12w7 in, I was wondering with it being 3 ohms could I still use my Kenwood KAC-X810D mono 1600/1 ohm, 800/2 ohm, 400/4 ohm amp. The ohms do not match up but if I bridge the amp into 2 ohms, could I be safe using it?