Recent content by Alex Kaminski

So, this also has been happening on and off recently. At first, when I turned my HU to 0 volume. It would pop super loud. Not good. But it didn't take long before it blew 2 of my 6x9s. So I looked things up and found it could be a grounding problem. I then made my grounds better. I ran the RCA...

Single voice coil. 12 inch performance series. It was a 2 channel lanzar 1200 watt amp

That mayyy actual have been the problem. Im quite sure I did have the amp bridged ! Ohp. Right now im on my mono block. But I wired them back to 4 ohms so I didn't damage them. I'll have to give it another shot in the mono

So I wired my 2 kenwood subs using the sonicelectronics wire diagram. And my amp is 2 ohm stable. And for some reason the just made a humming sound. And didn't work. Any reason for this ? Cuz right now I just have the wires going straight into the amp at 4 ohms. So to power them efficiently, my...

Yes. I know. Haha. Definitely the last of the speakers im adding. Just not enough room to put them. ! Im only using the 6x9sfor mids and highs. Figuring it should sound good since the 2 in the rear deck are 3 ways. And the other 4 are 4 ways. The only thing that is really. Really cheap are the...

Yes. Haha. I have considered getting a good/better HU. But I really seem to like my JVC cuz it's simple. And you could say I'm quite addicted to car audio. Along with just about every other person here I suppose. Im already running 2 kenwood 6.5s in the doors. 2 kenwood 6x9s in the rear deck...

Alrighy. Sweet. I'll set the sub amp to that. My head unit can only control the one set of rcas I have coming out of it. And that's what I need to be set to "through" supposably for the 6x9s to actually work. But doing that is what takes the sub amp from being set to low frequencies. You've been...

Update: My HU got changed to low frequencies believe it or not. So now I have it set to through. But that now also means my subs are playing on through. What should I have that amp set at to cancel out the high frequencies

Oddly enough. Still nothing. The woofer continues to work. And barely any high frequencies coming out. Could the amp somehow be broke ? I mean. It's obviously cheap. But could it have just broken the HIgh pass part of it ?

Alright sweet i'll give that a shot and keep everyone who has helped posted (: i have switched it to high but i didnt adjust the highpass

Here are the settings on the amp

No. I have my RCA's from my HU going to the back of my monoblock amp. And that piggie backed to the 2 channel. Just like how it was. Is there anything you can think of that I can try.

That's what I was thinking. But there's no switch. It's just a little dial. And no matter where I turn it. It sounds roughly the same. It's just weird that less than a month ago. It was powering them fine. And it's not like it's not powering them at all. The bass is hitting fine. But the voices...

So I have 2 kenwood 6x9s that i was powering with a lanzar 2 channel amp. However i switched it to power my 2 subs instead. Now after switching it back to the 6x9s. It's only playing low bass sounds. Like everything's only coming from the woofer. First I thought it was the speakers. But I...