Recent content by ajb1205

Amps and distribution block installed on a left over piece of Plexi. Have to clean up the wiring and carpet a bit once the weather warms up. Also installed a raptor steering wheel... And YES... The paddles are 100% functional. Also installed a HDC switch and then turned the feature on with...

Rear doors are deadened and sealed up and finished the rear wall. Sent from my SM-G955W using Tapatalk

Been busy the last couple weekends. Sent from my SM-G955W using Tapatalk

My 10tw3 suits me just fine. Its in a sealed enclosure that I made. Nice, tight bass but can also go low too. Money well spent IMHO. Sent from my SM-G955W using Tapatalk

A pillars in the works... Turned out as good as I could have expected! Sent from my SM-G955W using Tapatalk

After a ton of research and listening to sound boards, and bugging the hell out of the local stereo shops, I ended up installing Helix E series 6.5" comps up front and then the matching 6.5" coaxials in the rear doors. I also installed hushmat on and in each door...and am looking at finding...

Just trimming a hair off the plastic body immediately after the metal tab. Definitely a Micro2. Originally bought a mini so I know that 100%.

I know, hey?! Sent from my SM-G955W using Tapatalk

Long story short is that a fuse tap WILL work. You need to trim down the edges just a little. If you compare the end to a Micro2 fuse end you will see the difference.

Makes sense 100%. Thanks for the info and help!

I will try the back speakers and see what happens. As far as the DSP/amp combo, this is my "thinking"...please let me know if I am wrong or what you would recommend changing: Audison puts out 35w stereo or 130w bridged. Channel 1 & 2 - tweeters channels 3/4 & 5/6 bridged - front 6.5...

Here is my setup: 2018 F150 with non-BO stereo Helix 6.5 components up front Stock rear door speakers 4 gauge amp wiring kit JL JX5001D mono block JL 10" tw3 in selfmade box under rear seat I decided to run speaker level inputs to my amp, for the time being, since I will be installing an...

Sorry guys...factory head unit. Time to pull out the multimeter I guess. Sent from my SM-G955W using Tapatalk

Finally started the install on my 18 F150. So far I have: Helix 6.5" comps up front (off stock power for now) JL JX500D1 running a single 10" JL 10tw3 Will be adding an Audison 8.9 to run the front full active and then Helix 6.5 coaxials in the rear doors when funds allow. My issue is...

Stopped by the audio shop after work. Slight change of plans. Going with the Focal K2s up front and am going active as well. I may look at speakers in the rear doors but for now will leave them as is. Sent from my SM-G955W using Tapatalk