Recent content by Ahza2496

Hello, i have a noise problem recently and i am unable to locate the source, however i do have signs, the amp is kicker zr600 hooked up to kicker cvr 12x1, everytime i start the engine there is a noise, but when i touch the amp the noise immediately disappears, this never happened to my previous...

Thank you for your answers, i'll run the cvr at 8 ohms bridged (basically 4 ohms right?) Until i got another cvr or other pair of subs..

Yes the amp is two channel and i want to bridge the connection.. so the amp is seeing 1 ohm in bridged mode if i hook it up to the 2 ohm cvr? If 8 ohms (cvr voice coils wired in series) then the bridged impedance would be 4 ohm?

It's a dvc sub with 4 ohm per coil... wired it in series because last time i wired it parallel my previous amp died..

Hello, I have a kicker zr600 old school amp powering kicker comp vr 12.4. wired the sub in series to 8 ohm to avoid another amp death like my previous one, my question is, if i wired the kicker sub parallel to 2 ohm and bridge it on the zr600, what ohm will the amp see and can it be done?