Recent content by 67camaross

yea i think there worth it too my only concern is that i heard they burn the oil in the engine so u have to add oil more often so i am wondering if they could damage the rings and such if the flames are going back toward the engine. Also can i get those nice blue flames or will it just be the...

hey Anyone know about the Flame thrower kits sold by autoloc. I've seen them for 100 bucks plus cost of two coils and spark plugs. Baisicly i want to know what kind of damage this will do to my engine. I have a 67 camaro ss so the install should be pretty easy but just worried about damaging...

custom autosound

i just got my sd changer back from the company who was repairing it when i got it i hooked it up to the headunit in the front seat just to test it before i ran the wire again and it worked fine but then i unplugged it to run the wire and when i plugged it back in it won't work. when i turn the...

how do u check the backlash, precision calipers? also how do i know what the backlash should be

thanks for the help

hi i'm hooking a relay up to turn on my amp. I'm planning on hooking: 85 to the power antenna lead 86 to a ground 87 to the amps remote turn on 30 to the 12 volt If this is correct my question is fo the 30 to get the 12 volt can i hook that to the constant power terminal on my amp. i...

quick questio. i'm hooking up a relay and was just wondering what sze wire i should be using for the 12 volt power t it and ground thanks

what does inverted mean? Do you just have the sub facing into the box? Why would you do that does it produce better sound. Also when you mont the subs do you use the same scres you used to make the box or do you get srter ones that don't go all the way through. Also mine does not have trim...

ya i use it for both but i could have drilled to far on one sub and not he other right. if you don't hink it is "stripping" wha do u think could be wrong? thanks

ok i'll try moving it cause i did use a power drill so they are probaby stripped. what do u mean by te trim being loose and how would i fix that.

what gears you putting in

i'll try that as soon as i get a chance any other suggestions

i don't hear the grinding when i move the cone if this is what you mean and i don't hear anything when i shake the box i only hear it when i turn the volume up high but if i put pressure around the edge where the screws are the nois stops

hi anyone have any experience with changing rear end gears. i have a 67 camaro ss and i'm pretty sure there are highway gears in the rear end so i was thinking of putting in the 4:11's anyone know how hard it would be to do this myself? Any other comments on these gears and how would i know...