Recent content by 614Emil

Hi I am just wondering if anybody got experience with pioneers taa microphone setup? Have you ended upp using that config or change it alittle? Or ended upp doing the taa manually? Does pioneers taa setup adjust the eq curve on each speaker? I think so Share your experience

Hi i recently got a focal 3way up front and placed my focals ps 165 in the back doors and now 1 is blown, i think i set the crossover slope 1 space wrong or i pushed them just a little too high in bass wich means they are not good enough for me.. Now im thinking of maybe replace both 6.5 in...

worked wonderfully! drove 6 hours over the mountain after install/change, less distortion at lower volume and more fully sounded bass. need more soundproofing for my doors now ^^ it was 4 x 125wrms @ 4 ohm now: 2 x 365wrms @ 4 ohm

Thx i will try that :)

Can i bridge an 4 ch amp to 2ch and run focal kx3 3way on 4ohm load to each side? Do they run on 4ohm when not bi-amped? When bi-amped would the midbass get a 4 ohm load and the midrange and tweeter gets a 2ohm load since they are all 4 ohm?

Hi! I just got a set of kx3's that runs on a jbl px300.4 125 rms 4 ohm x4 165 rms 2 ohm x4 Or 360 rms 4 ohm x2 Right now the kx3's are on front 2ch and focal ps165 on rear ch. I also got another jbl px300.4 with defect front channels. I was thinking of running the kx3's on only 1 amp but...

Hi! Ive just replaced my set of focal ps 165 with focal kx3. I put the ps165 in the back doors and they produce better/punchy bass now than they did in the front doors. I can clearly hear the kx3 6.5" are better, more powerfull and play lower hz's, but i didnt get that much more punchyness of...

Hi :) i am trying to build a good sq setup in my vw passat b6. right now i got a diy 3way setup in front and 2 way in the back head unit: pioneer x3800dab dsp, taa.... 4channel amp: jbl px 300.4 1channel amp: ground zero 1000dxii front: focal ps165v1 3" from energy speakers 3 way crossover...