Recent content by 304290

i bought the x790 a few months ago. i first had it running a kove OD 6.2 6 1/2 componet set straight off of the unit. these were rated at handling 150 rms. with them running just off of the 790. they sounded great. no distortion, even with the volume all the way up. i was very surprised at how...

well here's my situation. i have a kove audio top of the line opulent OD 6.2 componet set. recently, one of my tweeters got shot. Kove audio has recently been bought out by us amps, and rep. told me that it would be sometime next year before they will have any replacement models. i can get a...

anybody who knows a little about car audio knows that no ohm load is constant. i think he assumed that i was using four ohm speakers because that would be close to 1.2 ohms he suggested . he said my amp will never see .66 ohms which is not true. if i connected enough speakers, it will see .66...

one type r dvc wired parallel is two ohms. according to the ohm law you divide the number of speakers into the ohm load. so if each speaker is two ohms, you divide 3 which is the number of speakers into 2 which is the ohm load. that number is .666. if they where four ohm speakers then it would...

i have 3 type r12s in a 3.3 cf shared sealed enclosure. i'm thinking about going with the lanzar opti 2000d. this amp has been tested at producing 1962rms @ .5 ohms. my type rs are dvcs, and all three would give me an impedance of .66 ohms. so i should still be getting around 1900 watts. is this...

does this amp do rated power 1400 watts at 1 ohm? i'm also considering lanzar heritage 2600d or vibe 1800d.

i have 3 alpine type r dvc 12s in a sealed enclosure. which of these amps should i go with. i can get the soundstream for 200, the opti 1400d for 220 and the vibe 1800d for 165.

i have 3 alpine type rs each with four ohm dvcs. my amp will only hande a four ohm bridged load. is there a way to wire these to see a four ohm load? if not, what should i do?

i'm trying to decide what type of box to use for my two L5 12s. i listen to everything from rap to jazz. i know that a ported box will be a lot louder, but sound quality won't be that great. is there a ported box design that will still have the sound quality to listen to jazz.? will it be a big...

i'm debating on whether to go with 2 L5s in sealed box or 2 rwe 15s also in a sealed box. i know going sealed over ported with the L5s will sacrifce some spl. however, i would gain sq. i know the quarts are specificly a sq woofer, but will having 15s be louder than the L5 12s in a sealed box.