Recent content by 15bass

The ground wire shorted out ur block. No power went past the block with the ground touching it. This caused BOTH amp and head unit to go into protect mode. It started working again when the ground moved? If it turned on and sounds fine, its OK. Advice: take the power n ground wires out that...

Alright!! I figured it out. Cuz the box terminal melted, I took it out. The hole from the terminal on the box caused my sub to over excursion. I just put a new terminal in and it fixed the problem. Thankx tho

I had 2 kicker comp cvr's in a ported box wired at 1ohm. I had a autotek atx2000.1 amp pushing them. Yes its 200 over, so what. As long as you know how to set an amp n don't b a show off with the bass knob, You'll be fine. Good luck

I bet its ur rem or power wire. I'm guessing power tho. With car off theirs less V being used so ur wire can handle it(even with the short), amp isn't shutting down Cuz ur wires g is thick enough for the 12-13v...15v with car on

2000 Watts, 1000 rms sub and amp. I used 16g, that's Wat the g was inside the box wen I got it.

Wireing in the box was fine

I have no idea. It worked fine then cut off(only sub). I popped the trunk n the + box terminal n speaker wire to amp was melted. All the wireing on the box was fine too. It was just the terminal on the box.

Ground might be loose. Check if the amp over heats. If it over heats its a bad amp.

Kicker comp cvr 12's? Cvr's are 800rms(pair) so the amp is a little small but would still work. I'd recommend a 2000 Watt amp for Max power. you should bridge the channels and depending on the ohms of the amp, You'll want to wire the subs in parellel for a dual voice coil sub. + to +, - to-...

Ace is right bout the y splutter for the RCA. 1 male - If the DVD players to big for the hole youll have to find someone to do some expensive fiberglass work. Otherwise you have the wrong kit.

Ur hed unit or RCA are prolly bad

Is the amp or mid range speakers hissing?

I have a 15" DB drive okur k9 powered by an autotek atc2000.1. The otherday the + box terminal melted n the wire also. I rewired everything with 8g wire. I hooked it up n now it sounds like crap!! I rechecked the wireing, voice coils, and cone. Everything's fine but major distortion. Is it...