Emo 10+ year member
Member
My problem is, i just received my router jig and was going to make some rings for my next box. Set-up was really easy, but read a couple places that I need to take the bit into concideration. i was wondering if that just with homemade jig and not the jasper. Because i'm using the 1/4 in. bit recommended, so i should be able to go with the measurements off of the jig?
Help
My rings will be
outer edge 10 1/12"
inside edge: 9 1/8"
where should i set my pivot points?
Thanks
Help
My rings will be
outer edge 10 1/12"
inside edge: 9 1/8"
where should i set my pivot points?
Thanks