Hello all !! New to the site here and had a question that I’m sure is very simple for you all but is a great mystery to me . I have a 5 channel amp that I will be using in my truck . 4 channels to the 4 doors and the 5th channel to a sub .. what I’m wanting to do is run the 4 doors at 4ohm and the sub at 2ohm . Is this possible to mismatch the ohm load between the 4 channels and the single channel .. thanks for any and all replies ..
-
2Participant count
-
Participant list
beak81champ
Senior VIP Member
It should be just fine. What amp, and which drivers are you using?
- Thread Starter
- #3
Great , I Appreciate it .. the Amp is a PPI 5.2200 , The 6.5s are Skar TX65C and I was waiting to order my subs when I knew the answer to this question so I got the right ones ..
Activity
No one is currently typing a reply...
Similar threads
Thanks for all the advice. Ultimately, I was able to get them to honor the warranty contract. It took a lot of back and forth and I received...
- Started by Chris Morton
- Wiring, Electrical & Installation
Never said they were. Commentary was more to being able to purchase one or the other or 40% off and take a 90 day warranty... which I would in a...
- Started by Fabian12
- Amplifiers
Lowering the impedance will also lower the speakers motor control, or damping, in physics no free lunch exists.
It’s all give and take.
- Started by Paul Curtis
- General Car Audio
https://www.amazon.com/dp/B07DLC9M48/?tag=caraudiocom-20
- Started by Mr FaceCaser
- Amplifiers 2
About this thread
