Reply to thread

Message

<blockquote data-quote="jasperpso" data-source="post: 1965523" data-attributes="member: 568842">i believe hondarider to be correct on that.&nbsp; the point of the xeload is to equalize all speaker connections to full power which it creates at 4 ohm..&nbsp;&nbsp; try 56.6 and see if those are the results you are looking for..&nbsp; but i have heard the assassins will take 450 daily so if it takes a bit more to pound like u want it, dont be afraid to push the amp a little harder..&nbsp; and it is air cooled, and i understand it will take it..&nbsp; i woudlnt run the mod..&nbsp; this amp should do it without the mod..&nbsp; you are giving those subs WAY too much power&nbsp; with th\at mod, and with that you risk blowing them..you might look at getting a phoenix gold &#039;line driver&#039;&nbsp; it essentiallly boosts the output level of the HU before it gets to the amp.. i have not personnaly used one, but it sounds like it would be right up your ally..i was just using a jvc HU with a 2v preout, and i had to run the gain nearly all the way up to get the output i wanted..&nbsp; more input signal(my new premiere hu)&nbsp; and it is down below halfway..</blockquote>

[QUOTE="jasperpso, post: 1965523, member: 568842"] i believe hondarider to be correct on that. the point of the xeload is to equalize all speaker connections to full power which it creates at 4 ohm.. try 56.6 and see if those are the results you are looking for.. but i have heard the assassins will take 450 daily so if it takes a bit more to pound like u want it, dont be afraid to push the amp a little harder.. and it is air cooled, and i understand it will take it.. i woudlnt run the mod.. this amp should do it without the mod.. you are giving those subs WAY too much power with th\at mod, and with that you risk blowing them.. you might look at getting a phoenix gold 'line driver' it essentiallly boosts the output level of the HU before it gets to the amp.. i have not personnaly used one, but it sounds like it would be right up your ally.. i was just using a jvc HU with a 2v preout, and i had to run the gain nearly all the way up to get the output i wanted.. more input signal(my new premiere hu) and it is down below halfway.. [/QUOTE]

Verification