Reply to thread

Message

<blockquote data-quote="NSTALN" data-source="post: 8310014" data-attributes="member: 588169">Not entirely sure, to be honest. I have 2 sets of tweets I like...I will obviously only use one pair but I haven&#039;t decided which. The rub is that one is 6ohms(Morel Supremo Piccolo)and the other is 4ohms(Alpine SPXpro RR). Hence why I was reaching out for both pairs, the Elate accomidates a 6ohm tweeter and the JL supports a 4ohm. As far as mids go, that&#039;s a bit undecided as well...depending on the mounting location I choose, I&#039;ll either go with Dayton Ref 3&#039;s or the new Dayton Ref 4&#039;s w/paper cone. I&#039;m leaning towards the 4&#039;s. Midbass will either be a set of SPXpro 6.5&#039;s but I may replace them with then new Dayton Ref 7&#039;s w/paper cone...if for no other reason than appeasing my OCD and preferring matching drivers.&nbsp; //content.invisioncic.com/y282845/emoticons/laugh.gif.48439b2acf2cfca21620f01e7f77d1e4.gifSo I&#039;m looking for a crossover that can give me at least 12db hi/low with points at 4-5khz and 400hz. I have a three way Linkwitz-Riley design with 3db &amp;amp; 6db LPad designed for each...just not sure I want to build my own...Parts alone are about $240. Considering I can get a pair of JL C5 3ways for $260 to my doorstep w/out having to build it(I confirmed the x-over points w/JL as 4.5k and 400 all at 12db per) that way be the way to go.</blockquote>

[QUOTE="NSTALN, post: 8310014, member: 588169"] Not entirely sure, to be honest. I have 2 sets of tweets I like...I will obviously only use one pair but I haven't decided which. The rub is that one is 6ohms(Morel Supremo Piccolo)and the other is 4ohms(Alpine SPXpro RR). Hence why I was reaching out for both pairs, the Elate accomidates a 6ohm tweeter and the JL supports a 4ohm. As far as mids go, that's a bit undecided as well...depending on the mounting location I choose, I'll either go with Dayton Ref 3's or the new Dayton Ref 4's w/paper cone. I'm leaning towards the 4's. Midbass will either be a set of SPXpro 6.5's but I may replace them with then new Dayton Ref 7's w/paper cone...if for no other reason than appeasing my OCD and preferring matching drivers. [IMG]//content.invisioncic.com/y282845/emoticons/laugh.gif.48439b2acf2cfca21620f01e7f77d1e4.gif[/IMG] So I'm looking for a crossover that can give me at least 12db hi/low with points at 4-5khz and 400hz. I have a three way Linkwitz-Riley design with 3db & 6db LPad designed for each...just not sure I want to build my own...Parts alone are about $240. Considering I can get a pair of JL C5 3ways for $260 to my doorstep w/out having to build it(I confirmed the x-over points w/JL as 4.5k and 400 all at 12db per) that way be the way to go. [/QUOTE]

Verification