Reply to thread

Message: <blockquote data-quote="qxfosgatesvt" data-source="post: 51314" data-attributes="member: 544134">ok i have 3 amps two mono and 1 normal 4ch amp,i dont have any distrobution blocks yet , so i was think this,can i run the power wire to 1 cap then run 1 amp of that cap and then run a power wire from the 1st cap to the 2nd cap and then run my othe2 amps of that,note i will not do this with the grounds i will give each cap there own ground,but would this work good until i get my blocks in a few weeks?</blockquote>

Top