Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
Worst car you've installed on?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Ferendon" data-source="post: 3509828" data-attributes="member: 578259"><p>2007 Dodge Caliber... 4 door locks, and an alarm... little over 9 hours of work, for Nick (mokedaddy) and I. I've never seen a door panel that needed that much **** removed to get a **** door panel off. 26 pieces total (panels/bolts/clips), to get the front ones off, and the rears where almost as bad. And 3 of the 10mm bolts that hold the front ones on, also hold the window sliders in place, so they get loose when you take the panel off. We had a problem with 1 window that popped off track, and just didn't want to stay seated. Had to remove the window from the clips, slide it up, then run the carriers into place to get it seated again. And more unfinished/burred areas than just about any other car I've dealt with. A system would have been easy though... The speaker covers pop right off with no problem. Good luck getting any decent wire through the door jamb boots, they have MAYBE a 3/8" ID.</p></blockquote><p></p>
[QUOTE="Ferendon, post: 3509828, member: 578259"] 2007 Dodge Caliber... 4 door locks, and an alarm... little over 9 hours of work, for Nick (mokedaddy) and I. I've never seen a door panel that needed that much **** removed to get a **** door panel off. 26 pieces total (panels/bolts/clips), to get the front ones off, and the rears where almost as bad. And 3 of the 10mm bolts that hold the front ones on, also hold the window sliders in place, so they get loose when you take the panel off. We had a problem with 1 window that popped off track, and just didn't want to stay seated. Had to remove the window from the clips, slide it up, then run the carriers into place to get it seated again. And more unfinished/burred areas than just about any other car I've dealt with. A system would have been easy though... The speaker covers pop right off with no problem. Good luck getting any decent wire through the door jamb boots, they have MAYBE a 3/8" ID. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
Worst car you've installed on?
Top
Menu
Home
Refresh