Reply to thread

Message

<blockquote data-quote="mli_699" data-source="post: 614906" data-attributes="member: 557976">I have (2) Lanzar MAX12D&#039;s dual voice coil subs @ 4 ohms per coil with a max wattage of 1000 watts @ 2 ohms and 500 watts @ 4 ohms each sub.(4ohm nom. impedance).&nbsp; I plan to connect them to a Lanzar HTG 244&nbsp; Heritage amp.&nbsp; 2x250W RMS at 4 OHMS. 2x500W Max at 4 OHMS1x1000W Max at 4 OHMS Bridged. 2x420W RMS at 2 OHMS and 2 Ohm Stereo Stable Operation Bridgeable at 4 OhmsTHD: 90dBChannel Separation: &amp;gt;65dBStereo, Bridge and Tri-Mode System Application CompatibleOne of two questions is: how do I wire the subs and the amp to get the most out of them.&nbsp; I saw some diagrams on one of the posts about the Fosgates but it was unclear to me because I only saw one positive and negative lead running from the amp to the subs.&nbsp; Was it a one-channel amp?&nbsp; If it was a two-channel amp, why wasn&#039;t leads running from the amp to one sub and then the other? Maybe I need to be explained about how the diagrams are set up. Any help?! I need a diagram that clearly shows how to wire subs with a two-channel amp. My other question is: what are the dimensions for a sealed enclosure per MAX12D.&nbsp; I have to have a sealed enclosure because I don&#039;t have much room in the trunk.&nbsp; I have a convertible and my trunk dimensions are: 14&quot;(H)x10&quot;(D)x38&quot;(W), which is pretty small.&nbsp; Do you recommend ports, and if so, what length, diameter, and position(top, side,front).&nbsp; Any help would be appreciated.</blockquote>

[QUOTE="mli_699, post: 614906, member: 557976"] I have (2) Lanzar MAX12D's dual voice coil subs @ 4 ohms per coil with a max wattage of 1000 watts @ 2 ohms and 500 watts @ 4 ohms each sub.(4ohm nom. impedance). I plan to connect them to a Lanzar HTG 244 Heritage amp. 2x250W RMS at 4 OHMS. 2x500W Max at 4 OHMS 1x1000W Max at 4 OHMS Bridged. 2x420W RMS at 2 OHMS and 2 Ohm Stereo Stable Operation Bridgeable at 4 Ohms THD: 90dB Channel Separation: >65dB Stereo, Bridge and Tri-Mode System Application Compatible One of two questions is: how do I wire the subs and the amp to get the most out of them. I saw some diagrams on one of the posts about the Fosgates but it was unclear to me because I only saw one positive and negative lead running from the amp to the subs. Was it a one-channel amp? If it was a two-channel amp, why wasn't leads running from the amp to one sub and then the other? Maybe I need to be explained about how the diagrams are set up. Any help?! I need a diagram that clearly shows how to wire subs with a two-channel amp. My other question is: what are the dimensions for a sealed enclosure per MAX12D. I have to have a sealed enclosure because I don't have much room in the trunk. I have a convertible and my trunk dimensions are: 14"(H)x10"(D)x38"(W), which is pretty small. Do you recommend ports, and if so, what length, diameter, and position(top, side,front). Any help would be appreciated. [/QUOTE]

Verification