Reply to thread

Message: <blockquote data-quote="Cm_low" data-source="post: 8552760" data-attributes="member: 671764"><p>As everyone else said wire it to 1 ohm set gains properly should be fine.  For your wire, is it ofc, welding cable, or cca?  If it ofc you are more than likely ok, just may wanna check amp and cable to see if it getting hot while pushing the system hard.  To be safe though you could run a 2nd run of 4 gauge ofc into dual power inputs and dual outputs for the ground to equal 0 gauge or just upgrade to 0 gauge.  If your running cca then upgrade to 0 for sure.</p></blockquote><p></p>

Top