Reply to thread

Message

<blockquote data-quote="Prowler573" data-source="post: 1864356" data-attributes="member: 561023">First you likely need to upgrade your Big 3. See <a href="http:////forum/showthread.php?t=152355" target="_blank">this thread</a> for detailed information on that.I would go with a run of 1/0awg cable from the battery going to wherever your amps are to be located then into a distribution block to feed the two amps. You&#039;ll need ground cable for those amps as well.If the Alpine head unit is a replacement for a stock stereo then do it the easy way and get yourself a factory wiring harness adapter so you can plug directly into the wires that the people that built your car saw fit to so kindly provide you with.You&#039;ll need speaker wire to feed the interior speakers off of that....wait a minute....you&#039;re going to use a monoblock amp to feed your interior speakers? 400.1? wtf?? (does Kicker even make a 400.1 monoblock? I&#039;m no expert on Stillwater products)You&#039;ll also need speaker wire to go from the 1200.1 to the sub enclosure and wire to connect the subs to the terminals in the enclosure (if applicable in your case)You need some small gauge wire for the remote accessory activation output from your head unit going to the amps to tell them when to turn on and off.You need RCA interconnects to bring the source signal to the amps.</blockquote>

[QUOTE="Prowler573, post: 1864356, member: 561023"] First you likely need to upgrade your Big 3. See [URL="http:////forum/showthread.php?t=152355"]this thread[/URL] for detailed information on that. I would go with a run of 1/0awg cable from the battery going to wherever your amps are to be located then into a distribution block to feed the two amps. You'll need ground cable for those amps as well. If the Alpine head unit is a replacement for a stock stereo then do it the easy way and get yourself a factory wiring harness adapter so you can plug directly into the wires that the people that built your car saw fit to so kindly provide you with. You'll need speaker wire to feed the interior speakers off of that....wait a minute....you're going to use a monoblock amp to feed your interior speakers? 400.1? wtf?? (does Kicker even make a 400.1 monoblock? I'm no expert on Stillwater products) You'll also need speaker wire to go from the 1200.1 to the sub enclosure and wire to connect the subs to the terminals in the enclosure (if applicable in your case) You need some small gauge wire for the remote accessory activation output from your head unit going to the amps to tell them when to turn on and off. You need RCA interconnects to bring the source signal to the amps. [/QUOTE]

Verification