Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
wiring jl w3d4 @ 2ohms on e4300
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="zxerox" data-source="post: 678007" data-attributes="member: 558808"><p>I have a jl 12w3d4 and a jl e4300 4 channel amp and a jl e1400D 1 channel amp. Because I am only using two of the channels on the 4 channel amp I would like to bridge the two remaining channels and have it run the sub. This way I could return the mono amp. The instruction manual for the 4 channel amp says it can handle 2ohm in stereo and 8ohm bridged. I wanted to know if bridging the channels and wiring this sub in parallel at 2 ohm will mess up my 4 channel amp.</p><p></p><p>Thank you</p><p></p><p>joseph</p></blockquote><p></p>
[QUOTE="zxerox, post: 678007, member: 558808"] I have a jl 12w3d4 and a jl e4300 4 channel amp and a jl e1400D 1 channel amp. Because I am only using two of the channels on the 4 channel amp I would like to bridge the two remaining channels and have it run the sub. This way I could return the mono amp. The instruction manual for the 4 channel amp says it can handle 2ohm in stereo and 8ohm bridged. I wanted to know if bridging the channels and wiring this sub in parallel at 2 ohm will mess up my 4 channel amp. Thank you joseph [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
wiring jl w3d4 @ 2ohms on e4300
Top
Menu
What's new
Forum list
