Reply to thread

Message

<blockquote data-quote="bamaboy" data-source="post: 635574" data-attributes="member: 557566"><p>thanks, i did that and it went in there and its holding for now but im going out there later and gonna redo it kinda. it was going into protection but if i wiggle the wire it comes back on( it was doing this a few times at first, but then it didnt do it again for atleast 30 minutes while i was using it which is when i cut it off, so i guess i got it working right. i9 have to get a drill anbd undo my SX so i can wire it to 1ohm, it was at 4 for my other amp. but i was getting mad at that speaker terminal. it seems like a little more work to have a terminal like that, but i dont know. my other amp was a POS, but the wire was easy to put in. i like the amp a lot for now, just not later when i have to take it out and do it again to get better grip. o yea my ground is 8 gauge and i would pull out because screw wasnt long enough so i put that glod clip thing on it and put it in there now it fits fine.</p></blockquote><p></p>

[QUOTE="bamaboy, post: 635574, member: 557566"] thanks, i did that and it went in there and its holding for now but im going out there later and gonna redo it kinda. it was going into protection but if i wiggle the wire it comes back on( it was doing this a few times at first, but then it didnt do it again for atleast 30 minutes while i was using it which is when i cut it off, so i guess i got it working right. i9 have to get a drill anbd undo my SX so i can wire it to 1ohm, it was at 4 for my other amp. but i was getting mad at that speaker terminal. it seems like a little more work to have a terminal like that, but i dont know. my other amp was a POS, but the wire was easy to put in. i like the amp a lot for now, just not later when i have to take it out and do it again to get better grip. o yea my ground is 8 gauge and i would pull out because screw wasnt long enough so i put that glod clip thing on it and put it in there now it fits fine. [/QUOTE]

Verification