Reply to thread

Message

<blockquote data-quote="Prowler573" data-source="post: 1973199" data-attributes="member: 561023">First off you do not bridge a sub. //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif Bridging is the term attached to combining two stereo amp channels into a single, mono output.For your purposes you will want to wire the DVC 2 Ohm L7 like so to make a 4 Ohm load:<img src="http://akamaipix.crutchfield.com/graphics/infolib/carlib/subs/1_2ohmDVC_4ohm.gif" alt="" class="fr-fic fr-dii fr-draggable " style="" />Then on the amp you&#039;ll want to connect the (+) output terminal from the left channel and the (-) output from the right channel to power the sub. If there is a switch on your amp for bridged operation then set it to the appropriate detent. If there&#039;s no switch then likely your amp auto-detects bridged mode and if so, you&#039;re gold. (Providing you don&#039;t have an older amplifier that requires an external module to run it bridged like some of the old HCCA Orions, etc)</blockquote>

[QUOTE="Prowler573, post: 1973199, member: 561023"] First off you do not bridge a sub. [IMG]//content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif[/IMG] Bridging is the term attached to combining two stereo amp channels into a single, mono output. For your purposes you will want to wire the DVC 2 Ohm L7 like so to make a 4 Ohm load: [IMG]http://akamaipix.crutchfield.com/graphics/infolib/carlib/subs/1_2ohmDVC_4ohm.gif[/IMG] Then on the amp you'll want to connect the (+) output terminal from the left channel and the (-) output from the right channel to power the sub. If there is a switch on your amp for bridged operation then set it to the appropriate detent. If there's no switch then likely your amp auto-detects bridged mode and if so, you're gold. (Providing you don't have an older amplifier that requires an external module to run it bridged like some of the old HCCA Orions, etc) [/QUOTE]

Verification